Abstract:Resin Transfer Molding (RTM), which has attracted much attention in the last years for lightweight manufacturing, represents an important challenge in terms of control technology. During the process, a resin fills the cavity where a reinforcement fabric has previously been layered. This resin undergoes a chemical reaction which is thermically activated. Therefore, assuring a proper reaction requires a precise control of temperature in the entire mold cavity. Three factors make this control problem especially hard: the coupling among the large number of actuators and sensors, the variability of the test conditions and the power limitations of the electric actuators which do not offer cooling capability. The present work describes an optimized Model Predictive Control (MPC) architecture capable of handling these difficulties and also achieving the tight control requirements needed in the application. The thermal distribution inside the mold cavity is included into the controller by a simplified Reduced Order Model (ROM). This representation is obtained by data from an experimentally validated Finite Element Model (FEM), using AutoRegressive model with eXogenous terms (ARX) identification. In order to maintain the simplicity of this linear representation, the time-varying model parameters are estimated by using a perturbation observer. Additionally, the performance of the basic algorithm is improved: firstly, an augmented observer to estimate the temperature distribution of an extended spatial resolution; and secondly, a symmetry condition in the calculation of the control commands. The developed architectures have successfully been implemented in a RTM tool with the fulfillment of the control requirements.

Adaptive Model Predictive Control of a Batch Solution Polymerization Process using Trajectory Linearization

Constrained Nonlinear Model Predictive Control of an MMA Polymerization Process via Evolutionary Optimization

Adaptive Model Predictive Control Scheme for Partially Internal Thermally Coupled Air Separation Column

Simultaneous Optimization and Control for Polypropylene Grade Transition with Two-Layer Hierarchical Structure

Nonlinear model predictive control of HTR-PM load changing process

Dynamic Matrix Control of a Quadruple-Tank Process

Adaptive nonlinear model predictive control for a class of multivariable chemical processes

Dynamic Optimization of Batch Free Radical Polymerization with Conditional Modeling Formulation Through the Adaptive Smoothing Strategy

Temperature Control of an Acrylonitrile Polymerization Kettle Using Multiple Models with Second Level Adaptation

Optimal control of molecular weight and particle size distributions in a batch suspension polymerization reactor

High-order Volterra Model Predictive Control and Its Application to a Nonlinear Polymerisation Process

Tracking Control for Batch Processes Through Integrating Batch-to-Batch Iterative Learning Control and Within-Batch On-Line Control

Adaptive Predictive Control Algorithm for Batch Processes: Application to a Rotational Molding Process

CNN-LSTM-Based Nonlinear Model Predictive Controller for Temperature Trajectory Tracking in a Batch Reactor

Predictive Control Based on Reduced Order Model for temperature homogeneity in a resin transfer molding tool for thermoset materials

Integrated tracking control of batch processes with model uncertainties by updating a linear perturbation model

A Multi-Objective Model Predictive Control for Temperature Control in Extrusion Processes

Fuzzy Multi‐model Based Adaptive Predictive Control and Its Application to Thermoplastic Injection Molding

Trajectory tracking of batch processes with varying control interval and incrementally updated models

Batch-to-batch Model-Based Iterative Optimisation Control for a Batch Polymerisation Reactor

Robust controller design for temperature tracking problems in jacketed batch reactors