Abstract:Residual stresses can have detrimental effect on the life cycle of engineering components and can affect the accuracy of the fatigue life prediction models. Accurate measurement of these stresses are therefore crucial. . However, destructive and semi-destructive methods of measuring residual stresses often cause damage to the components. In contrast, the non-destructive ultrasonic method allows for intact measurement of residual stresses even, in situation where portability is not feasible. Various waves can be utilized in the ultrasonic method for measuring residual stresses. In this study, longitudinal critically refracted (LCR) waves were employed due to their higher sensitivity, larger scanning area, and lower sensitivity to texture effect, making them preferable over other waves. The purpose of this study was to investigate the influence of plasticity on the measurement of residual stresses using the ultrasonic method. To achieve this, two stainless steel disks were subjected to quenching at temperatures of 300 °C and 700 °C to induce different levels of residual stresses and plasticity. The material properties of the disks were determined through standard tensile tests to facilitate numerical simulations. Tensile test specimens were extracted from the initial sheet to measure the yield stress and modulus of elasticity. The coefficient of acoustoelasticity, was determined by subjecting the tensile test specimens to different stress levels and recording the wave flight time. The coefficient of acoustoelasticity for stainless steel 316Lwas obtained using the slope of and (E(t-t0))/t0,. Residual stresses were experimentally measured using both the ultrasonic method and the center-hole drilling method, and the results were compared with those obtained from numerical analyses. The findings from center-hole drilling method, ultrasonic method, and numerical simulation were then compared and discussed. Different levels of plasticity were considered, and the accuracy of measuring residual stresses was analyzed and evaluated.

In situ monitoring of plastic deformation using ultrasound

Ultrasound as a probe of dislocation density in aluminum

Nonlinear acoustic characterization of heterogeneous plasticity in bent aluminium samples

Measuring Dislocation Density in Aluminum with Resonant Ultrasound Spectroscopy

Acoustic anisotropy and localization of plastic deformation in aluminum alloys

Contribution of Dislocation Evolution to Acoustic Nonlinearity in Plastically Damaged Materials

Assessment of Material Dislocation Damage by Nonlinear Ultrasound

Non-destructive evaluation of non-uniform stress fields and subsurface stress gradients using ultrasonic waves

Monitoring of Environmental Loading Effect on the Steel with Different Plastic Deformation by Diffuse Ultrasound

Experimental and Numerical Studies of Nonlinear Ultrasonic Responses on Plastic Deformation in Weld Joints

Modeling of Ultrasonic Nonlinearities for Dislocation Evolution in Plastically Deformed Materials: Simulation and Experimental Validation.

Direct detection of plasticity onset through total-strain profile evolution

In situ nonlinear Rayleigh wave technique to characterize the tensile plastic deformation of stainless steel 316L

Evaluation of plastic damage for metallic materials under tensile load using nonlinear longitudinal waves

Plastic Deformation Behavior of Ti Foil Under Ultrasonic Vibration in Tension

A study on the effect of plasticity on the measurement of residual stresses using ultrasound technique

Dislocation dynamics simulation research of ultrasonic vibration assisted micro upsetting

Quantitative testing of residual deformation in plate with varying thickness based on nonlinear ultrasound

Monitoring stress related velocity variation in concrete with a $2.10^{-5}$ relative resolution using diffuse ultrasound

Investigation of Plastic Yielding in Near-Micrometer Grain Size Aluminum Using Synchrotron Microdiffraction

Noninvasive Measurement of Local Stress Inside Soft Materials with Programmed Shear Waves