Infrared Spectroscopy with Visible Light

Dmitry A. Kalashnikov,Anna V. Paterova,Sergei P. Kulik,Leonid A. Krivitsky

DOI: https://doi.org/10.1038/nphoton.2015.252

2015-06-24

Abstract:Spectral measurements in the infrared (IR) optical range provide unique fingerprints of materials which are useful for material analysis, environmental sensing, and health diagnostics. Current IR spectroscopy techniques require the use of optical equipment suited for operation in the IR range, which faces challenges of inferior performance and high cost. Here we develop a spectroscopy technique, which allows spectral measurements in the IR range using visible spectral range components. The technique is based on nonlinear interference of infrared and visible photons, produced via Spontaneous Parametric Down Conversion (SPDC). The intensity interference pattern for a visible photon depends on the phase of an IR photon, which travels through the media. This allows determining properties of the media in the IR range from the measurements of visible photons. The technique can substitute and/or complement conventional IR spectroscopy techniques, as it uses well-developed optical components for the visible range.

Quantum Physics,Optics

What problem does this paper attempt to address?

The problem that this paper attempts to solve is the challenges faced in measuring the optical properties of materials in the infrared (IR) spectral range. Traditional infrared spectroscopy techniques require the use of specialized infrared light sources, detectors, and optical elements, which often have poor performance and high cost. This paper proposes a new spectroscopy technique that can measure the refractive index and absorption coefficient of a medium in a wide infrared range using components in the visible light range without using infrared devices.

Specifically, this technique is based on the principle of nonlinear interference and utilizes the nonlinear interference effect between infrared and visible photons generated by spontaneous parametric down - conversion (SPDC). By measuring the interference pattern of visible photons, the properties of the medium in the infrared range can be inferred. This method can not only replace or supplement traditional infrared spectroscopy techniques, but also utilize optical components in the visible light range that are already very mature and low - cost to achieve.

The paper describes in detail the experimental setup and method, including using two SPDC crystals to generate signal photons (visible light) and idler photons (infrared light), and determining the refractive index and absorption coefficient of the medium by analyzing the interference fringes of visible photons. The experiment takes carbon dioxide gas as an example to demonstrate the effectiveness and accuracy of this technique in practical applications.