Load-Modulated Single-RF MIMO Transmission for Spatially Multiplexed QAM Signals

Seung-Eun Hong,Kyoung-Sub Oh

DOI: https://doi.org/10.48550/arXiv.1501.01725

2015-01-08

Abstract:Today, MIMO has become an indispensable scheme for providing significant spectral efficiency in wireless communication and for future wireless system, recently, it goes to two extremes: massive MIMO and single-RF MIMO. This paper, which is put in the latter, utilizes load-modulated arrays with only reactance loads for single-RF transmission of spatially multiplexed QAM signals. To alleviate the need for iterative processes while considering mutual coupling in the compact antenna, we present a novel design methodology for the loading network, which enables the exact computation of the three reactance loads per antenna element and also the perfect matching to the source with the opportunity to select appropriate analog tunable loads. We verify the design methodology by comparing the calculated values for some key parameters with the values from the circuit simulation. In addition, as an evaluation of the proposed architecture, we perform the bit error rate (BER) comparison which shows that our scheme with ideal loading is comparable to the conventional MIMO.

Information Theory

What problem does this paper attempt to address?

This paper aims to solve several key problems faced by single - radio - frequency (Single - RF) multiple - input multiple - output (MIMO) systems in wireless communications. Specifically, the paper proposes a design method for MIMO transmission of single - RF load - modulated arrays (LMA), especially for quadrature amplitude modulation (QAM) signals with spatial multiplexing. The main problems and solutions are as follows:

1. **Reducing hardware complexity and power consumption**:
- The paper points out that the deployment of traditional MIMO systems is limited due to the need for multiple radio - frequency (RF) links, widely - spaced antenna elements, and high power consumption. To overcome these problems, the paper proposes a design method using a single RF link and a compact antenna array containing only reactive loads.

2. **Accurately calculating load values**:
- In order to avoid the iterative process in the case of considering mutual coupling between antennas, the paper provides a new design method that can accurately calculate the three reactive load values required for each antenna unit and achieve perfect matching with the source. This makes it possible to select appropriate analog tunable loads to adapt to different passive loading circuits.

3. **Solving phase error and amplitude adjustment**:
- The paper also solves the problems of phase error and amplitude adjustment when transmitting spatially multiplexed symbols, and provides closed - form equations to determine the values of design parameters.

4. **Verifying the effectiveness of the design method**:
- The effectiveness of the design method is verified by comparing the calculated key parameter values with circuit simulation results. In addition, the paper also conducts a bit error rate (BER) comparison, and the results show that the performance of the LMA - MIMO system using ideal loads is comparable to that of traditional MIMO systems.

In summary, the main contribution of this paper is to propose a design method suitable for single - RF LMA - MIMO transmission, which can effectively solve problems such as hardware complexity, power consumption, phase error, and amplitude adjustment, and verify its effectiveness through simulation and experiment.