Abstract:Aiming to evaluate the serviceability performance of bridge piers after potential terrorist attacks or accidental explosions, the residual seismic performance of post-blast reinforced concrete (RC) piers was studied by performing the test and numerical simulation. Firstly, the field explosion and successive lateral cyclic loading tests were performed on two 1/2-scale RC piers, and a single lateral cyclic loading test was performed on two intact control piers for comparison. The test data such as the incident overpressure-time histories, as well as the damage profiles, hysteretic curves and skeleton curves of piers, etc. were obtained and fully discussed. Then, an integrated finite element (FE) analysis approach based on the explicit–implicit switching algorithm was proposed to reproduce the dynamic and quasi-static responses of RC piers under blast and successive lateral cyclic loadings. Furthermore, four commonly used concrete material models were systematically compared and evaluated based on the basic mechanical property, explosion, and lateral cyclic loading tests. Finally, by comparing with the test data, the applicability of concrete material models and corresponding parameters, as well as the proposed integrated FE analysis approach for the residual seismic performance analysis of post-blast RC piers were verified comprehensively. It is concluded that: (i) after 0.5 kg TNT explosion, the positive yield and peak forces obtained from the lateral cyclic loading test are close to those of the intact control piers, whereas the negative yield and peak forces decrease to 66 % and 70 % of the intact ones; (ii) after 1.0 kg TNT explosion, the positive yield and peak forces are 77 % and 81 % of the intact values, while the negative yield and peak forces are only 37 % and 42 % of the intact ones; (iii) by replacing the explicit algorithm with implicit algorithm during the residual seismic performance analysis, the computational cost is saved by about 70 times; (iv) Winfrith concrete model can better predict the residual seismic performance of post-blast RC piers, with the deviations limited in 20 %. The present work can provide a reference for the designer and researchers in evaluating the seismic performance of the post-blast RC bridge piers during the whole service life.

Explosion responses of movable π -shaped box bridge: Experimental and numerical investigations

Experimental Study and Numerical Analysis of A Composite Bridge Structure

Research of Loading Effects of Blast in Air

Dynamic Response of a Box Multistage Stiffened Beam under the Coupling of Vehicle Load and Air Blast Load

Numerical Study of Damage Modes and Assessment of Circular RC Pier under Noncontact Explosions

Analysis of the failure mechanism of multi-beam steel–concrete composite bridge under car explosion

Damage mechanism and assessment of precast double-column bridge piers under blast impact

Damage modes and mechanism of steel-concrete composite bridge slabs under contact explosion

Experimental study on protection of prestressed concrete box girder under vehicle explosion of bridge deck

Investigation on Damage Mechanism of RC Column under Close-in Explosion

Dynamic responses of buried arch structure subjected to subsurface localized impulsive loading: Experimental study

Field test and probabilistic vulnerability assessment of a reinforced concrete bridge pier subjected to blast loads

Dynamic Response of High Strength Steel Beams Subjected to Explosion Induced Blast Load

Dynamic response and performance of cable-stayed bridges under blast load: Effects of pylon geometry

Damage Mechanism Of Reinforced Concrete Slab Under Internal Blast Loading

Numerical analysis of axial load effects on RC bridge columns under blast loading

Experimental investigation on dynamic response and damage models of circular RC columns subjected to underwater explosions

Damage modes and mechanism of steel box arch ribs under contact explosion

Experimental and Numerical Study on the Mechanical Behavior of Composite Steel Structure under Explosion Load

Experimental and numerical study on the residual seismic performance of post-blast RC piers

Dynamic Response Parameter Analysis of Steel Frame Joints under Blast Loading