Abstract:All-carbon flexible supercapacitors are highly promising in powering up wearable electronics in smart textiles. However, their low energy density hinders their practical application due to the lack of an effective fabrication method of highly conductive fiber electrodes with high specific capacitance. Herein, we develop a sustainable, scalable, and cost-effective method to fabricate lignin-based carbon/graphene fiber (GF) hybrid electrodes with a hierarchically porous structure. This engineered structure is achieved by coaxially wet spinning a graphene oxide fiber (GOF) as a core structural support and 0–10% lignin/graphene oxide (GO) as a surface layer, followed by carbonization and KOH activation processes. The obtained fiber electrodes exhibit the highest specific capacitance of 260.48 mF cm–2 at a current density of 0.1 mA cm–2, which is 11 times that of the neat GF from conventional wet spinning. The entire-device energy density of the assembled fiber-based flexible supercapacitors from the optimal fiber electrode is 5.79 μW h cm–2 in a H2SO4/poly(vinyl alcohol) electrolyte. Furthermore, the fiber-based flexible supercapacitors show ultralong cycling life and cycling stability (the capacitance retention rate is 98% after 7000 cycles of charge/discharge at a current density of 0.1 mA cm–2). This work enables the high-value utilization of low-cost carbon precursors (lignin and GO) in potential applications such as energy storage devices for smart textiles.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsaem.1c01379.Polarized optical microscopy image of GO solution at 15 mg mL–1; SEM images of the neat GF and unactivated 5% ; FTIR images of the GOF and GF; CV and GCD curves of the GF, unactivated 5% recorded at 5 mV s–1 and 0.1 mA cm–2; CV and GCD curves of flexible supercapacitors tested in a 2-electrode cell in 1 M H2SO4/PVA electrolyte of 0–10% ; electrical conductivity of ; calculated CA, CV, Esingle,A, and Psingle,A values of fiber electrodes based on GCD curves at a current density of 0.1 mA cm–2; calculated CA of fiber electrodes at different scan rates based on CV measurements; and calculated CA of fiber electrodes at current densities based on GCD measurements (PDF)This article has not yet been cited by other publications.

Fabrication of Flexible Super Capacitor Using Laser Lightscribe Technique

Direct Graphene Deposition via a Modified Laser-Assisted Method for Interdigitated Microflexible Supercapacitors

Fabrication of Laser Scribed Graphene Stretchable Supercapacitor by Laser-Assisted Transfer Printing Strategy

A Facile and Scalable Fabrication of High-Performance Flexible Laser-Induced-Graphene Micro-Supercapacitors Using Ultrafast Pulse Laser

One-step fabrication of flexible, cost/time effective and high energy storage graphene-based supercapacitor

Boosting Supercapacitive Performance of Flexible Carbon Via Surface Engineering.

Supercapacitors Fabricated via Laser-Induced Carbonization of Biomass-Derived Poly(furfuryl alcohol)/Graphene Oxide Composites

Flexible Ultrathin Micro-Supercapacitors Based on Laser-Reduced Graphene with Superior Electrochemical Performance and Aesthetic Property

Enhancing supercapacitor performance through design optimization of laser-induced graphene and MWCNT coatings for flexible and portable energy storage

Optimization studies on output stabilization time and graphene oxide concentration in graphene-based flexible micro-supercapacitor

Direct Laser Writing of Flexible Planar Supercapacitors Based on GO and Black Phosphorus Quantum Dot Nanocomposites

Electrochemical Performance of Coaxially Wet-Spun Hierarchically Porous Lignin-Based Carbon/Graphene Fiber Electrodes for Flexible Supercapacitors

Direct laser writing of micro-supercapacitors on hydrated graphite oxide films

Laser fabrication of graphene-based supercapacitors

Fabrication of flexible planar micro-supercapacitors using laser scribed graphene electrodes incorporated with MXene

Conductive Writing with High Precision by Laser‐Induced Point‐to‐Line Carbonization Strategy for Flexible Supercapacitors

Performance characterization of flexible printed supercapacitors

Laser photonic-reduction stamping for graphene-based micro-supercapacitors ultrafast fabrication

Tuning the Electronic and Electrochemical Properties of 3D Porous Laser‐Induced Graphene by Electrochemically Induced Deposition of Polyoxovanadate Nanoclusters for Flexible Supercapacitors

New insights on laser-induced graphene electrodes for flexible supercapacitors: tunable morphology and physical properties