Advanced Concepts in Josephson Junction Reflection Amplifiers

Pasi Lähteenmäki,Visa Vesterinen,Juha Hassel,G. S. Paraoanu,Heikki Seppä,Pertti Hakonen
DOI: https://doi.org/10.1007/s10909-014-1170-0
2014-05-20
Abstract:Low-noise amplification atmicrowave frequencies has become increasingly important for the research related to superconducting qubits and nanoelectromechanical systems. The fundamental limit of added noise by a phase-preserving amplifier is the standard quantum limit, often expressed as noise temperature $T_{q} = \hbar {\omega}/2k_{B}$. Towards the goal of the quantum limit, we have developed an amplifier based on intrinsic negative resistance of a selectively damped Josephson junction. Here we present measurement results on previously proposed wide-band microwave amplification and discuss the challenges for improvements on the existing designs. We have also studied flux-pumped metamaterial-based parametric amplifiers, whose operating frequency can be widely tuned by external DC-flux, and demonstrate operation at $2\omega$ pumping, in contrast to the typical metamaterial amplifiers pumped via signal lines at $\omega$.
Mesoscale and Nanoscale Physics,Quantum Physics
What problem does this paper attempt to address?
The problem that this paper attempts to solve is to achieve low - noise amplification in the microwave frequency range, especially in the case close to the quantum limit. Specifically, the authors developed a reflection amplifier based on the inherent negative - resistance characteristics of the Josephson junction and studied its performance in broadband microwave amplification. In addition, they also explored the metamaterial parametric amplifier composed of superconducting quantum interference device (SQUID) arrays using external DC magnetic - flux tuning to achieve a wider range of frequency tuning and 2ω pumping operations. ### Main problems: 1. **Low - noise amplification**: In the research of superconducting qubits and nano - electromechanical systems, low - noise amplification is becoming increasingly important. The noise temperature \(T_q=\frac{\hbar\omega}{2k_B}\) at the quantum limit is the fundamental noise limit of phase - preserving amplifiers. 2. **Broadband microwave amplification**: Traditional amplifier designs are difficult to achieve high gain and low noise over a relatively wide frequency band. Therefore, new methods need to be developed to achieve broadband, low - noise microwave amplification. ### Solutions: 1. **Single - Josephson - junction reflection amplifier (SJA)**: - Utilize the inherent negative - resistance characteristics of the Josephson junction to achieve the negative - resistance effect under appropriate biasing conditions. - By introducing frequency - selective shunting (such as LCR band - stop filter), stabilize the negative - resistance branch, thereby achieving broadband amplification. - Experimental results show that this amplifier can obtain a linear gain of approximately 10 dB in the frequency range from 2.6 GHz to 2.8 GHz, and the gain - bandwidth product (GBW) can reach 500 MHz. 2. **Metamaterial parametric amplifier**: - Use a metamaterial composed of 250 SQUIDs, embedded in a coplanar waveguide resonator, and tune the resonant frequency through external DC magnetic - flux. - Through 2ω pumping operations, achieve parametric gain different from traditional signal - line pumping, avoiding the interference of strong pumping signals on the measurement bandwidth. - Experimental results show that this amplifier can achieve a maximum gain of up to 24 dB, and the resonant frequency can be adjusted between 5 GHz and 6 GHz through external magnetic - flux tuning. ### Challenges and improvements: - **Noise compression mechanism**: Although broadband gain has been achieved, the noise compression mechanism is weak in the current experiment, resulting in an increase of 10 - 20 quanta of noise in the amplifier. - **Microwave loss**: Under high - power pumping, the microwave loss of the metamaterial amplifier is relatively serious, affecting the gain performance. Future designs need to be optimized to reduce these losses. In summary, this paper aims to solve the problem of low - noise amplification in the microwave frequency range through new - type Josephson - junction reflection amplifiers and metamaterial parametric amplifiers, and explore how to approach the quantum - limit noise performance.