Joint measurement of current-phase relations and transport properties of hybrid junctions using a three junctions SQUID

J. Basset,R. Delagrange,R. Weil,A. Kasumov,H. Bouchiat,R. Deblock

DOI: https://doi.org/10.1063/1.4887354

2014-07-18

Abstract:We propose a scheme to measure both the current-phase relation and differential conductance $dI/dV$ of a superconducting junction, in the normal and the superconducting states. This is done using a dc Superconducting Quantum Interference Device (dc SQUID) with two Josephson junctions in parallel with the device under investigation and three contacts. As a demonstration we measure the current-phase relation and $dI/dV$ of a small Josephson junction and a carbon nanotube junction. In this latter case, in a regime where the nanotube is well conducting, we show that the non-sinusoidal current phase relation we find is consistent with the theory for a weak link, using the transmission extracted from the differential conductance in the normal state. This method holds great promise for future investigations of the current-phase relation of more exotic junctions.

Mesoscale and Nanoscale Physics

What problem does this paper attempt to address?

The key problem that this paper attempts to solve is: **How to measure the current - phase relationship (CPR) and differential conductance (dI/dV) of a superconducting junction simultaneously, and be able to carry out these measurements in both the normal state and the superconducting state**. Specifically, the author proposes a new experimental scheme, using a DC SQUID (superconducting quantum interference device) with three contact points to achieve this goal.

### Main problem decomposition:

1. **Measurement of current - phase relationship (CPR)**:
- It is difficult for the traditional SQUID configuration to obtain differential conductance information while measuring CPR.
- The paper proposes an improved SQUID geometry. By introducing two reference Josephson junctions and an additional central contact point, the differential conductance can be measured while measuring CPR.

2. **Measurement of differential conductance (dI/dV)**:
- In the normal state, it is necessary to be able to measure the differential conductance of the weak link to characterize the quality of the weak link.
- In the superconducting state, it is also necessary to be able to measure the differential conductance to study the superconducting characteristics.

3. **Application and verification**:
- The author has experimentally proved the effectiveness of this method by measuring a small Josephson junction and a carbon nanotube junction respectively.
- For the carbon nanotube junction, the author shows a non - sinusoidal current - phase relationship and explains this phenomenon through the transport theory.

### Specific solutions:

- **Three - contact - point SQUID structure**: By introducing two reference Josephson junctions and an additional central contact point, the differential conductance can be measured without affecting the CPR measurement.
- **Asymmetric SQUID design**: Ensure that the critical current of the large junction is much higher than that of the weak link, so as to achieve more accurate CPR measurement.
- **Temperature effect and noise processing**: Consider the influence of temperature and current noise on the measurement results, and propose an effective temperature model to explain the experimental data.

### Experimental verification:

- **Small Josephson junction**: Verify the feasibility of this method in the traditional Josephson junction, and obtain the expected sinusoidal current - phase relationship.
- **Carbon nanotube junction**: Demonstrate the application potential of this method in more complex systems, especially in the carbon nanotube quantum dots of strongly coupled superconducting leads, observe the non - sinusoidal current - phase relationship, and explain it through the transport theory.

In conclusion, this paper proposes an innovative experimental method that can simultaneously measure the current - phase relationship and differential conductance on the same sample, providing a powerful tool for future research on more complex superconducting junctions.