Abstract:This article concerns the mathematical justification of an averaged system of partial differential equations governing the evolution of a two-phase mixture of heat non-conductive, compressible fluids, in space dimension 1 with periodic boundary conditions. The first step is to write a system of partial differential equations governing the physics at a mesoscopical level where the two phases are separated by sharp interfaces. In a second step we study the behavior of a sequence of solutions corresponding to highly oscillating initial densities and temperatures. The limit of such a sequence is described byan averaged system of partial differential equations that has a different algebraic structure than the mesoscopic model and that reflects the macroscopical properties of the mixture. The originality of the paper consists in the fact that both the density and temperature are allowed to oscillate, so that the limiting model is a six-equation, two-pressures, two-temperatures model. The key point is to show the strong convergence of the stress tensor in $L^2((0, T) \times (0, 1))$. In order to obtain uniform estimates in spite of the presence of oscillating coefficients in the energy equation, we look at solutions with low regularity for the density and the temperature.For the readers convenience, we provide in a separated section the modelization of the mesoscopic system and the formal derivation of the averaged two-phase system. We also provide, at the end of the paper, numerical illustrations comparing the unknowns solving the mesoscopic system and the one satisfying the averaged two-phase system.

Derivation of a homogenized two-temperature model from the heat equation

Homogenization of a thermo-poro-elastic medium with two-components and interfacial hydraulic/thermal exchange barrier

Modeling of heat conduction through rate equations

A note on a two-temperature model in linear thermoelasticity

Homogenization and simulation of heat transfer through a thin grain layer

Mathematical Justification of a Compressible Two-Phase Averaged System with Temperature but Without Heat Conductivity

Two-fluid modeling of heat transfer in flows of dense suspensions

A Thermodynamically Consistent Phase-Field Model and an Entropy Stable Numerical Method for Simulating Two-Phase Flows with Thermocapillary Effects

Physical modeling of simultaneous heat and mass transfer: species interdiffusion, Soret effect and Dufour effect

Non-isothermal diffuse interface model for phase transition and interface evolution

Effective Heat Transfer Between a Porous Medium and a Fluid Layer: Homogenization and Simulation

Homogenization of Phase Transition Problems with Evolving Microstructure

A heat conduction equation for heterogeneous media and its connections to various known equations

Asymptotic Behavior and Numerical Simulations of a Conservative Phase-Field Model with Two Temperatures

Temperature dependent extensions of the Cahn–Hilliard equation

Thermal Inclusions Inside A Bounded Medium

Development of a general heat conduction model for two-phase heterogeneous solid mixture based on mixture theory

Neutral Inhomogeneities in a Two-dimensional Steady-state Heat Conduction Problem

Interaction between initial behavior of temperature and the mean curvature of the interface in two-phase heat conductors