Abstract:Heterostructures of TiO2@Fe2O3 with a specific electronic structure and morphology enable us to control the interfacial charge transport necessary for their efficient photocatalytic performance. In spite of the extensive research, there still remains a profound ambiguity as far as the band alignment at the interface of TiO2@Fe2O3 is concerned. In this work, the extended type I heterojunction between anatase TiO2 nanocrystals and α-Fe2O3 hematite nanograins is proposed. Experimental evidence supporting this conclusion is based on direct measurements such as optical spectroscopy, X-ray photoemission spectroscopy, scanning electron microscopy, high-resolution transmission electron microscopy (HRTEM), and the results of indirect studies of photocatalytic decomposition of rhodamine B (RhB) with selected scavengers of various active species of OH•, h•, e-, and •O2-. The presence of small 6-8 nm Fe2O3 crystallites at the surface of TiO2 has been confirmed in HRTEM images. Irregular 15-50 nm needle-like hematite grains could be observed in scanning electron micrographs. Substitutional incorporation of Fe3+ ions into the TiO2 crystal lattice is predicted by a 0.16% decrease in lattice parameter a and a 0.08% change of c, as well as by a shift of the Raman Eg(1) peak from 143 cm-1 in pure TiO2 to 149 cm-1 in Fe2O3-modified TiO2. Analysis of O 1s XPS spectra corroborates this conclusion, indicating the formation of oxygen vacancies at the surface of titanium(IV) oxide. The presence of the Fe3+ impurity level in the forbidden band gap of TiO2 is revealed by the 2.80 eV optical transition. The size effect is responsible for the absorption feature appearing at 2.48 eV. Increased photocatalytic activity within the visible range suggests that the electron transfer involves high energy levels of Fe2O3. Well-programed experiments with scavengers allow us to eliminate the less probable mechanisms of RhB photodecomposition and propose a band diagram of the TiO2@Fe2O3 heterojunction.

Ab initio study of the TiO$_2$ Rutile(110)/Fe interface

Ab initio molecular dynamics study of Fe adsorption on TiN (001) surface

Interactions in the Fe/TiO2(110) System

Stabilizing Fe Single Atoms on Rutile-TiO2(110) Surface Via Atomic Substitution

Detailed Atomistic Investigation of Fe-doped Rutile Phases.

Ordered Fe(II)Ti(IV)O3 Mixed Monolayer Oxide on Rutile TiO2(011).

Fe(II)Ti(IV)O 3 Mixed Oxide Monolayer at Rutile TiO 2 (011): Structures and Reactivities

Study of Rutile (110) Surface Stm Image Via Ab-Initio Simulation

An Ordered Mixed Oxide Monolayer Formed by Iron Segregation on Rutile-Tio2(011): Structural Determination by X-Ray Photoelectron Diffraction

Observation of Metallic TeO2 Thin Film with Rutile Structure on FeTe Surface

Monolayer Intermixed Oxide Surfaces: Fe, Ni, Cr, and V Oxides on Rutile TiO2(011)

Leed and Arups studies on Fe/Ru(10(1)over-bar0) surface

First-principles Study of Structural, Electronic, and Optical Properties of the Rutile TiO2(011)-2×1 Surface

The electronic structures of Fe-and V-doped rutile TiO_2 from first-principles calculations

Direct In-Situ Insights into the Asymmetric Surface Reconstruction of Rutile TiO2 (110)

Ab Initio Study of Phase Stability in Doped TiO2

Direct in-situ insights into the asymmetric surface reconstruction of rutile TiO 2 (110)

Scavenger-Supported Photocatalytic Evidence of an Extended Type I Electronic Structure of the TiO2@Fe2O3 Interface

Geometric Structure of Rutile Titanium Dioxide (111) Surfaces

Transition Metal Atoms Pathways on Rutile TiO2 (110) Surface: Distribution of Ti3+ States and Evidence of Enhanced Peripheral Charge Accumulation

Electronic structure study of TiO2 polymorphs, evaluation of formic acid adsorption on dry (001) and (100) TiO2(B) facets by DFT calculations