Abstract:The finite element model of oblique penetration of short-rod projectile into a thin metal target was established and the effectiveness of the model was verified to study the oblique penetration law of short-rod projectile into a thin metal target. The simulation calculation of short-rod projectile penetrating thin metal targets with different obliquities at different impact velocities was carried out. The simulation results show that the critical ricochet velocity of the projectile increased with the increase of the obliquity of the target plate, as well as the increment of the critical ricochet velocity of the projectile. With the increase in the obliquity of the target plate, the ultimate penetration velocity of the projectile increases exponentially, and when the obliquity is large, the ultimate penetration velocity increases sharply. When the projectile ricocheted without invading the target, the velocity attenuation of the projectile increased with the increase of the impact velocity, whereas the mass of the residual projectile decreased. However, when the impact velocity exceeds the ultimate penetration velocity of the projectile to the target plate, the velocity attenuation of the projectile decreased and the mass of the residual projectile increased with the increase of the impact velocity. With the increase of impact velocity, the included angle decreased gradually, and the decreasing trend also slowed down. When the impact velocity was just greater than the ultimate penetration velocity, the included angle was the largest. At the same impact velocity, the greater the obliquity of the target plate, the greater the included angle. This study is of great significance to reveal the critical ricochet and ultimate penetration of projectile, the velocity, mass, and trajectory change in the process of penetration, as well as the damage of projectile to the target plate.

The effects of various intermediate targets on dispersion of shotgun patterns

Effects of Target Thickness and Macroscopic Interface on the Ballistic Performance of Ti6Al4V Titanium Alloy

Numerical simulation of the disk fragment impacting resistance of plate target

Simulation of ballistic performance of a two-layered structure of nanostructured metal and ceramic

[Peculiar features of experimental damages on fabric targets caused by ricocheted bullets fired from a smooth-bore hunting gun]

Effects of Different Elastic Number and Thickness Ratios on Damage Mechanism of Aramid /UHMWPE Composite Target Plate

Oblique penetration law of short-rod projectile into thin metal target

Terminal ballistics performance of 9 × 19 mm cartridges in 10% ballistic gelatin: FBI Protocol based analysis of Brazilian-made law enforcement ammunition

Investigation on the influence of strength and density of jacket materials on the penetration performance of jacketed rods

Effect of ceramic particles reinforcement on the ballistic resistance of friction stir processed thick AA6061 surface composite targets

Experimental on the projectile penetration concrete targets and reinforced concrete targets

Performance of concrete targets mixed with coarse aggregates against rigid projectile impact

Impact resistance performance and structural optimization of lightweight composite target plate

The deceleration of full metal jacket bullets in compact target models – A new approach

Evaluation of the Impact Resistance of Steel–Aluminum Laminated Target Plates with Isoplanar Density

Effect of projectile diameter on ballistic resistance and failure mechanism of single and layered aluminum plates

Effects of kinetic energy and firearm‐to‐target distance on fracture behavior in flat bones

Research on ricochet and its regularity of projectiles obliquely penetrating into concrete target

Experimental investigation on the ballistic resistance of monolithic and multi-layered plates against hemispherical-nosed projectiles impact

Numerical and analytical investigation of ballistic performance of composite targets with ceramic-polyurea-metal layers and optimization of the layer thicknesses

The Effects of Compressibility and Strength on Penetration of Long Rod and Jet