Abstract:Supercapacitors are gaining increasing attention for complementing or replacing batteries and they are highly desirable in applications where high power and long cycle life of energy storage devices are needed. Activated carbons (AC) are the most promising electrodes in the supercapacitor industry presenting the best performances/cost compromise. Recently, graphene, with a two dimensional carbon nanostructure, has emerged as a new class of promising electrode material in supercapacitors, due to its outstanding properties such as high electric conductivity, high surface area, good mechanical properties and chemical inertia. Among the various approaches to producing graphene materials, here we focus on reduced exfoliated graphene oxide (r-GO) derived from chemically synthesised graphene oxide (GO). However, the graphene materials prepared by either chemical or thermal reduction of the graphene oxide always exhibits a relatively low electrochemical performance due to the agglomeration of graphene sheets and does not reflect the intrinsic capacitance of an individual graphene nano-sheet. To exploit the potential electrochemical applications for graphene, a particularly attractive option is to design and develop composites of graphene with other materials. In this study, we present an approach to synthesize a composite of reduced graphene oxide (r-GO) with activated carbon and its use as an electrode material in supercapacitors. To the best of our knowledge, a few studies on the preparation of GO/AC composites have been reported so far. Graphene oxide was synthesised using vein graphite by a modified Hummers method and then mixed with activated carbon to prepare a homogeneous composite. The composite was thermally reduced to convert GO in to r-GO. The morphology and chemical structure of the materials were characterized by means of Electron microscopy, Raman spectroscopy, X-ray diffraction and Fourier Transform Infrared Spectroscopy. Thermal properties were investigated using Thermo Gravimetric Analysis. The electrochemical properties of as obtained composites with different mass ratios were investigated, together with their individual components (GO, r-GO and AC) for comparison. For electrochemical characterisation, two-electrode symmetrical supercapacitor cells were constructed and characterized by cyclic voltammetry and electrochemical impedance spectroscopy. Tetraethylammonium tetrafluoroborate (TEABF4) in Propylene Carbonate (PC) was used as the electrolyte. The CV curves were measured from 0 to 1 V with various scan rates ranging from 10 to 1000 mV s −1 and the CV data were used to calculate the specific capacitances of the electrodes. The results showed that the as-prepared composites exhibited an improved electrochemical performance as compared to pure r-GO or AC. This improvement can be attributed to the synergistic effect of AC and r-GO. The maximum specific capacitance observed for the r-GO/ AC composite was 115.6 F/g at a scan rate of 10 mV s -1 . The near-rectangular CV curves at ultrafast sweep rate of 1000 mV s -1 indicated very efficient charge transfer within the composite electrodes. The incorporation of rGO into AC, not only provides the vacancies to accommodate ions, but also forms a promising network structure to conductively bridge the spaces between the AC particles, which can facilitate rapid transport of the electrolyte ions within the electrode materials, leading to a high-rate performance of the supercapacitor. Within the composite, r-GO plays the role of both the binder and the conductive additive increasing the specific capacitance and the power density of the devices.

Addition of reduced graphene oxide to carbon shaft based on cerbera manghass mesocarp to improve energy storage performance of supercapacitor cells

Coin‐Shaped Carbon Prepared with Cerbera manghas Fibers via Multistage Carbonization and Activation for High‐Performance Symmetrical Supercapacitors

Biomass valorization of Mangifera Indica into hierarchical carbon materials with self-doping oxygen assisted carbonization for supercapacitor applications

Porous carbon derived from cashew nut husk biomass waste for high-performance supercapacitors

Graphene Oxide and Activated Carbon Composites for High-Power Supercapacitors

Co2SiO4/CoO Heterostructure Anchored on Graphitized Carbon Derived from Rice Husks with Hierarchical Pore As Electrode Material for Supercapacitor

Biochar-derived material decorated by MXene/reduced graphene oxide using one-step hydrothermal treatment as high-performance supercapacitor electrodes

Reduced Graphene Oxide on Activated Carbon/Manganese Dioxide Composite Materials for High-Performance Supercapacitor Electrodes

Multilayer Reduced Graphene Oxide Deposited on Carbon Sheet as Electrodes for Supercapacitor Device

Two Steps for Improving Reduced Graphene Oxide/Activated Durian Shell Carbon Composite by Hydrothermal and 3-D Ball Milling Process for Symmetry Supercapacitor Device

Self-single-doped hierarchical porous carbon nanofiber derived Alpinia galanga stem-based for boosted supercapacitor performance

Carbon-carbon dense network composite with hierarchical structure for additive-free and high volumetric performance supercapacitor

Fabrication of a supporting kapok‐carbon/rGO electrode via self-assembly with enhanced capacitance

Synthesis and electrochemical performance of biomass-derived porous carbon materials for supercapacitors

Momordica Grosvenori Shell-Derived Porous Carbon Materials for High-Efficiency Symmetric Supercapacitors

Dual Tuning of Biomass-Derived Hierarchical Carbon Nanostructures for Supercapacitors: the Role of Balanced Meso/Microporosity and Graphene

Bio-waste derived 2 D rGO sheet supported Co 9 Se 8 hybrid composite electrode for high performance supercapacitor applications

Potassium citrate mediated self-restacking of graphene oxide to highly-microporous carbon nanosheets for high-performances supercapacitor

Chinar fruit fluff-derived mesopore-dominant hierarchical porous carbon for high-performance supercapacitors

Hierarchical-nanofiber structure of biomass-derived carbon framework with direct CO2 activation for symmetrical supercapacitor electrodes

Conversion of high moisture biomass to hierarchical porous carbon via molten base carbonisation and activation for electrochemical double layer capacitor