Abstract:In a radio interferometer, the determination of geometrical antenna positions relies on accurate calibration of the dry and wet delay of the atmosphere above each antenna. For the Atacama Large Millimeter/Submillimeter Array (ALMA), which has baseline lengths up to 16 kilometers, the geography of the site forces the height above mean sea level of the more distant antenna pads to be significantly lower than the central array. Thus, both the ground level meteorological values and the total water column can be quite different between antennas in the extended configurations. During 2015, a network of six additional weather stations was installed to monitor pressure, temperature, relative humidity and wind velocity, in order to test whether inclusion of these parameters could improve the repeatability of antenna position determinations in these configurations. We present an analysis of the data obtained during the ALMA Long Baseline Campaign of Oct. through Nov. 2015. The repeatability of antenna position measurements typically degrades as a function of antenna distance. Also, the scatter is more than three times worse in the vertical direction than in the local tangent plane, suggesting that a systematic effect is limiting the measurements. So far we have explored correcting the delay model for deviations from hydrostatic equilibrium in the measured air pressure and separating the partial pressure of water from the total pressure using water vapor radiometer (WVR) data. Correcting for these combined effects still does not provide a good match to the residual position errors in the vertical direction. One hypothesis is that the current model of water vapor may be too simple to fully remove the day-to-day variations in the wet delay. We describe possible avenues of improvement, including measuring and applying more accurate values of the sky coupling efficiency of the WVRs.

How ALMA is calibrated: I Antenna-based pointing, focus and amplitude calibration

On The Accuracy Of The Alma Flux Calibration In The Time Domain And Across Spectral Windows

ALMA High-frequency Long-baseline Campaign in 2017: A Comparison of the Band-to-band and In-band Phase Calibration Techniques and Phase-calibrator Separation Angles

Advanced Gain Calibration Techniques in Radio Interferometry

Learning Antenna Pointing Correction in Operations: Efficient Calibration of a Black Box

Measurement and Correction of Pointing Error Caused by Radio Telescope Alidade Deformation based on Biaxial Inclination Sensor

Calibration of an SKA-Low Prototype Station Using Holographic Techniques

Study of the Dynamics of Large Reflector Antennas with Accelerometers

New methods for ALMA angular-scale based observation scheduling, quality assessment, and beam shaping II: refinements

Calibration errors in interferometric radio polarimetry

The Simons Observatory: Antenna control software integration and implementation

Calibration artefacts in radio interferometry. III. Phase-only calibration and primary beam correction

Calibration of an SKA‐Low Prototype Station Using Holographic Techniques

Analysis of antenna position measurements and weather station network data during the ALMA Long Baseline Campaign of 2015

Licking the plate: dusty star-forming galaxies buried in the ALMA calibration data

Phase Calibration of Distributed Antenna Arrays

Ionospheric Calibration of Low Frequency Radio Interferometric Observations using the Peeling Scheme: I. Method Description and First Results

Calibration and imaging challenges at low radio frequencies: An overview of the state of the art

ALMA High-frequency Long-baseline Campaign in 2017: An Investigation of Phase-referencing Cycle Times and Effective Baseline Lengths Using Band-to-band and In-band Phase Calibration Techniques

ALMACAL. XII. Data characterisation and products

ALMA North American Integration Center Front-End Test System