Raman excitation spectroscopy of carbon nanotubes: effects of pressure medium and pressure

A.J. Ghandour,A. Sapelkin,I. Hernandez,D.J. Dunstan,I.F. Crowe,M.P. Halsall
DOI: https://doi.org/10.1080/08957959.2011.649280
2012-05-10
Abstract:Raman excitation and emission spectra for the radial breathing mode (RBM) are reported, together with a preliminary analysis. From the position of the peaks on the two-dimensional plot of excitation resonance energy against Raman shift, the chiral indices (m, n) for each peak are identified. Peaks shift from their positions in air when different pressure media are added - water, hexane, sulphuric acid - and when the nanotubes are unbundled in water with surfactant and sonication. The shift is about 2 - 3 cm-1 in RBM frequency, but unexpectedly large in resonance energy, being spread over up to 100meV for a given peak. This contrasts with the effect of pressure. The shift of the peaks of semiconducting nanotubes in water under pressure is orthogonal to the shift from air to water. This permits the separation of the effects of the pressure medium and the pressure, and will enable the true pressure coefficients of the RBM and the other Raman peaks for each (m, n) to be established unambiguously.
Mesoscale and Nanoscale Physics
What problem does this paper attempt to address?
The main problem that this paper attempts to solve is about the Raman spectral changes of carbon nanotubes (CNTs) under different pressure media and pressure conditions. Specifically, the research aims to: 1. **Clearly distinguish the effects of pressure media and pressure on Raman spectra**: - The research has found that the Raman spectra of different pressure media (such as water, hexane, sulfuric acid) and carbon nanotubes after debundling in water will change significantly. These changes are reflected not only in the shift of the radial breathing mode (RBM) frequency but also in the change of resonance energy. - By comparing the Raman spectra under different media and pressure conditions, researchers hope to separate the effects caused by the pressure medium and those caused by the pressure itself. 2. **Determine the accurate pressure coefficients of carbon nanotubes with different chiral indices (\((m, n)\))**: - Through systematic measurement of Raman spectra under different media and pressure conditions, researchers hope to obtain the pressure coefficients of RBM and other Raman peaks for each chiral - index carbon nanotube. This will help to understand the behavior of carbon nanotubes in high - pressure environments more accurately. 3. **Explain the inconsistency of experimental results**: - Although past research has been carried out for more than ten years, the results among different laboratories are inconsistent and even do not conform to simple theoretical models. For example, the pressure coefficients of the G - band vary greatly in different studies and there is no consistent change pattern. This paper hopes to clarify these inconsistencies through systematic research and provide more reliable data. ### Specific problems - **Change in RBM frequency**: Research shows that when carbon nanotubes are exposed to different media, the RBM frequency has a blue shift of 2 - 3 cm\(^{-1}\). - **Change in resonance energy**: More significantly, the change range of resonance energy can reach 100 meV, especially when sulfuric acid is used as the medium, this change is particularly obvious. - **Orthogonality of pressure effects**: Under the application of pressure, the peak shift direction of semimetallic carbon nanotubes in water is orthogonal to the peak shift direction when transferred from air to water. This indicates that the effects of pressure media and pressure on Raman spectra can be clearly distinguished. ### Conclusion Through this research, the authors hope to provide a clearer understanding of the behavior of carbon nanotubes in high - pressure environments and provide reliable data support for future research. In particular, they hope to clearly distinguish the specific effects of pressure media and pressure on the Raman spectra of carbon nanotubes through two - dimensional spectral maps (Kataura maps), so as to extract accurate pressure coefficients for carbon nanotubes of each chiral index.