Modulational instability of a recent nonlinear plasmonic metamaterial: Finite-difference-time-domain simulations

Yi S. Ding,Jiasen Zhang,Ruo-Peng Wang
DOI: https://doi.org/10.48550/arXiv.1204.5555
2012-04-25
Abstract:By doing time-domain simulations, we find the proposal for negative-to-positive index switching proposed in [Physical Review Letters, 106 105503 (2012)] may be fragile. The negative opinion on the uniform switching of local optical constants in our recent paper [<a class="link-https" data-arxiv-id="1111.1476v2" href="https://arxiv.org/abs/1111.1476v2">arXiv:1111.1476v2</a>] based on the circuit model of metamaterials can therefore be verified in this specific and realistic case.
Materials Science,Mesoscale and Nanoscale Physics
What problem does this paper attempt to address?
The problem that this paper attempts to solve is about the feasibility and stability of the negative - to - positive index switching of a recently proposed nonlinear plasmonic metamaterial. Specifically, the authors are skeptical about whether this switching effect proposed in previous studies can be achieved under practical conditions, and they verified this skepticism through Finite - Difference - Time - Domain (FDTD) simulations. ### Background and Problem Description 1. **Doubts about Previous Studies**: - In the previous literature [Physical Review Letters, 106 105503 (2012)], the authors proposed a novel nonlinear metamaterial and discovered the positive - to - negative index switching effect related to its bistable branches. - However, the authors of this paper raise questions about the practical realizability of this switching effect, especially in terms of uniformly switching the local optical constants. 2. **Influence of Mode Instability**: - The literature [Photonics and Nanostructures Fundamentals and Applications 4, 69 (2006)] points out that if the nonlinear metamaterial is regarded as a nonlinear lattice, the modulation instability caused by mutual inductance will occur within the bistable range, thereby suppressing the expected magnetization and completely destroying the sharp switching effect of the local optical constants. - This instability is particularly severe in dense structures because the mutual inductance between adjacent atoms may be comparable to the self - inductance. ### Research Methods and Results 1. **FDTD Simulations**: - The authors used the FDTD method to perform time - domain simulations on the above - mentioned structures to verify the influence of modulation instability. - The simulation results show that the responses between different meta - atoms are non - uniform, and there are even complex and non - uniform response patterns on the same phase plane. - The hot - spot phenomenon was observed, which further confirms the existence of modulation instability (such as self - focusing in Kerr materials). 2. **Comparison of Linear and Nonlinear Responses**: - The linear spectral analysis of a single meta - atom shows that there is a magnetic resonance at 410 THz. - Nonlinear response simulations indicate that even for two points at equivalent positions, their electric field intensities will deviate significantly, which is not in line with the expectations in the linear case. ### Conclusions Through FDTD simulations of nonlinear metamaterials, the authors found that modulation instability will lead to complex, non - uniform responses, and these results are contradictory to the uniformly switching effect assumed in previous studies. Therefore, this paper aims to reveal the limitations and potential problems of the negative - to - positive index switching of this nonlinear metamaterial in practical applications. ### Examples of Formulas Some physical quantities and formulas mentioned in the paper include: - **Linear Resonance Frequency**: $\omega_{\text{res}} = 410 \text{ THz}$ - **Central Frequency**: $\omega_0 = 405 \text{ THz}$ - **Time Width of Gaussian Pulse**: $\Delta t = 600 \text{ fs}$ - **Peak Intensity**: $I_{\text{peak}} = n_2I_0$, where $n_2$ is the nonlinear refractive index. These formulas and parameters are used to describe the simulation conditions and experimental settings.