Abstract:Abstract This paper proposes a cascaded low-pass filter (CLPF) scheme for the control of a unified power quality conditioner (UPQC) installed for enhancing the power quality of an electric vehicle (EV) charging station. With the incorporation of UPQC, the EV charging station draws sinusoidal currents at unity power factor and the supply voltage is maintained at the nominal value at the charger input. In the CLPF scheme, the α–β components of the load current are individually processed through a cascade connection of two LPFs to determine the corresponding fundamental orthogonal components. Based on thus determined components, the instantaneous and peak value and phase angle of the fundamental positive sequence component (FPSC) of the load current are computed. Similarly, the corresponding quantities related to the load and supply voltages are also computed with the CLPF scheme. With the computations related to the load current and supply voltage, the unit voltage templates (UVTs), power factor and fundamental active component (FAC) of the load current are calculated. For the control of shunt compensation, reference currents are generated based on the FAC of the load current and UVTs. Alternately, the control of series compensation is employed with the help of UVTs and peak amplitude of the FPSC of the load voltage. The performance of CLPF scheme-based extraction is compared with that of the earlier reported schemes through simulation and experimental studies. The performance comparison reveals a faster dynamic and more accurate steady-state response with the proposed scheme. The performance analysis of the proposed CLPF scheme-based control of a UPQC deployed at the EV charging station for different operating conditions demonstrates station operation with requisite reactive power compensation and mitigation of voltage sag/swell, and prevention of propagation of harmonic and unbalanced currents into the grid. This results in increased reliability of charger operation, energy savings and increased efficiency of the distribution network.

Applied Integrated Active Filter Auxiliary Power Module for Electrified Vehicles With Single-Phase Onboard Chargers

High Power Density Z-Source Resonant Wireless Charger with Line Frequency Sinusoidal Charging

An Integrated Design of Power Converters for Electric Vehicles.

Integrated High- and Low-Frequency Current Ripple Suppressions in a Single-Phase Onboard Charger for EVs

High-Frequency High-Density Bidirectional EV Charger

Second-Harmonic Ripple Voltage Suppression of Integrated Single-Phase Pulsewidth Modulation Rectifier Charging System for EVs

Power Decoupling Control for Single-Stage On-Board Chargers

An Integrated Power Decoupling Method for Single-Phase EV Onboard Charger in V2G Application

Design and Analysis of High Power Density On-Board Charger with Active Power Decoupling Circuit for Electric Vehicles

A Low Impact V2H Battery Charging Station Using an AC Green Plug Switched Filter Scheme

Active Power Decoupling for a Modified Modular Multilevel Converter to Decrease Submodule Capacitor Voltage Ripples and Power Losses

A three-phase four-wire three-level active power filter based on one-cycle control

A New Hybrid Active Power Filter Topology with Continuous Compensation Bandwidth and Small Active Capacity

A Modular Multilevel Converter with Active Power Filter for Submodule Capacitor Voltage Ripples and Power Losses Reduction

A single-phase shunt active power filter based on cycle discrete control for DC bus voltage

Frequency Design of Three-phase Active Front-End Converter with Reduced Filter in EV Chargers

EV charging station with cascaded low-pass filtering scheme-based control of unified power quality conditioner

A Novel Active Power Filter for High Voltage Application

A Control Strategy to Smooth Power Ripple of a Single-Stage Bidirectional and Isolated AC-DC Converter for Electric Vehicles Chargers

A modular multilevel converter with active power filter (APF-MMC) under low-frequency operation

A new type of active power filter with cycle discrete controller on DC bus voltage