Abstract:We propose and demonstrate accurate 3D real-time indoor localization via broadband nonlinear backscatter in passive devices. The proposed method does not need any relative motion between a reader and a tag or the use of reference anchor nodes. In the conventional radio frequency identification (RFID) system, a passive tag responds to a reader by switching its antenna "on" and "off". The operation of such conventional backscatter is essentially "linear", since the reader-to-tag (downlink) and tag-to-reader (uplink) signals overlap on the same carrier frequency. Although linear backscatter is straightforward, the self-jamming problem caused by strong leakage signals from the transmitter to the receiver is notorious and poses many constraints on the received signal quality, operation bandwidth, modulation flexibility and system complexity. To enable high accuracy real-time 3D indoor localization for passive devices, we show that nonlinear backscatter is more effective than linear backscatter. Nonlinear backscatter exploits nonlinear elements in passive devices to generate second or higher-order harmonics as the uplink response. Separation of downlink and uplink on different carriers allows immediate self-jamming cancellation and direct un-modulated carrier phase decoding, hence resulting in better received signal quality and broad bandwidth of operation, both of which are critical for the localization system. The broad bandwidth allows the design of an efficient phase-based ranging algorithm - heuristic multi-frequency continuous wave (HMFCW) ranging which resolves ambiguous phase cycles with heuristically optimized sparse carrier frequencies. HMFCW ranging can correctly pin down the phase cycle integer with 100% reliability as long as the phase error falls within 90 x BW% (percentage bandwidth). In our present implementation, we achieved a median ranging error below 1 cm under phase error bounds of 50. We realized real-time 3D localization from differential ranging by nonlinear conjugate gradient (CG) search for hyperboloids intersection in a multi-static transceiving system with 1 Tx antenna and 4 Rx antennas. The measured 3D localization median er-ror was 3.5 cm in the indoor environment. Presently, the measurement latency was less than 0.155 seconds. We will present system design, algorithms and a prototype with experimental evaluation.

Multifrequency Phase Difference of Arrival Range Measurement: Principle, Implementation, and Evaluation

RFID Tag Ranging Measurement Based on Multi-frequency Carrier Phase Difference

A Range-Free Localization of Passive Rfid Tags Using Mobile Readers

Localization and Tracking of an Indoor Autonomous Vehicle Based on the Phase Difference of Passive UHF RFID Signals.

RFID Indoor Localization System for Tag and Tagfree Target Based on Interference

Signal Descriptions and Formulations for Long Range Uhf Rfid Readers

Dual Frequency Based Real Time Location System Using Passive UHF RFID

Less is More: Efficient RFID-Based 3D Localization

Two-dimension localization of passive RFID tags using AOA estimation

An Indoor Localization System Based on Backscatter RFID Tag

Integrated Algorithms for RFID-based Multi-Sensor Indoor/outdoor Positioning Solutions

Design of Real Time Location System for UHF RFID

Design and implementation of a passive UHF RFID-based Real Time Location System

PATL: A RFID Tag Localization Based on Phased Array Antenna.

Phase-based Variant Maximum Likelihood Positioning for Passive UHF-RFID Tags

3d Real-Time Indoor Localization Via Broadband Nonlinear Backscatter In Passive Devices With Centimeter Precision

Passive IoT Localization Technology Based on SD-PDOA in NLOS and Multi-Path Environments

An RFID Tag Localization Based on Phased Array Antenna

Passive Multiple Target Indoor Localization Based on Joint Interference Cancellation in an RFID System

Non-Line-of-Sight Localization of Passive UHF RFID Tags in Smart Storage Systems

3D Passive Positioning Based on RFID Tag Array