Abstract:The article presents the results of an exergetic analysis of two new thermodynamic cycles: the Allam cycle and the cycle of a compressorless combined-cycle plant (the JIHT cycle). Their fundamental feature is that the carbon dioxide produced during fossil-fuel combustion can be removed directly from the power-installation cycle. Owing to this feature, such installations become extremely attractive for performing energy decarbonization. The JIHT cycle based installations are more versatile because they can be used for generating not only electricity but also heat for district heating purposes; in addition, they open the possibility to remove carbon dioxide from the cycle not in gaseous but in liquid form, which is more convenient for transportation to a consumer and/or for storage. It is shown that the electrical efficiency of an installation based on the Allam cycle makes 58.1% and that of the JIHT cycle installation operating in the cogeneration mode makes 45.5% with the total fuel efficiency equal to 92.5%. If there is no heat supply, the JIHT cycle electrical efficiency approaches that of the Allam cycle. The calculations are supported by detailed presentation of the considered cycles on a T , s diagram. The processes in which the main exergy loss occurs are highlighted. A conclusion is drawn that the installations considered can really compete with the conventional power installations with carbon dioxide capturing by means of sorption and membrane methods. To verify the procedure and computation model, an exergetic analysis was preliminarily performed for a conventional GTU-110 simple cycle gas-turbine unit, a 325 MWe combined-cycle plant (CCP) based on this unit, and a Capstone C30 microturbine with regeneration. The key scientific-technical problems that have to be solved for successfully harnessing the considered innovative cycles are highlighted. They include the development of a regenerative heat exchanger with a recovery ratio higher than 95% operating at a temperature of approximately 1000 K, an oxy–fuel combustion chamber for a pressure above 30 MPa, and a combined-cycle turbine with working fluid with an inlet temperature of higher than 1400 K and pressure above 30 MPa. These problems do not seem to be more complex than those that were set forth and successfully solved in the development of modern high-temperature high-capacity gas-turbine units.

Part-load thermal efficiency enhancement in gas turbine combined cycles by exhaust gas recirculation

Enhancing the Energy Performance of a Gas Turbine: Component of a High-Efficiency Cogeneration Plant

PERFORMANCE COMPARISON OF GAS TURBINE CYCLE COMBINED WITH SUPERCRITICAL CO2 RECOMPRESSION AND REGENERATIVE CYCLE

Thermodynamic analysis of a gas turbine cycle with direct recuperation based on a multistage compressed mass storage process

Improvement Design and Analysis of a Supercritical CO2/transcritical CO2 Combined Cycle for Offshore Gas Turbine Waste Heat Recovery

Thermoeconomic analysis and multiobjective optimization of a combined gas turbine, steam, and organic Rankine cycle

Thermo-economic Analysis and Multi-Objective Optimization of a Novel Waste Heat Recovery System with a Transcritical CO2 Cycle for Offshore Gas Turbine Application

Comprehensive thermodynamic, environmental, and economic analyses of a modified waste heat recovery process for a gas turbine cycle producing power, cooling, and hydrogen

Research and Development of the Combined Cycle Power Plants Working on Supercritical Carbon Dioxide

Operation and control of compact offshore combined cycles for power generation

Techno-Economic Comparison of Several Technologies for Waste Heat Recovery of Gas Turbine Exhausts

Techno-economic analysis of cascaded supercritical carbon dioxide combined cycles for exhaust heat recovery of typical gas turbines

Part-load performance analysis of a combined cycle with intermediate recuperated gas turbine

Exergoeconomic Evaluation of a Cogeneration System Driven by a Natural Gas and Biomass Co-Firing Gas Turbine Combined with a Steam Rankine Cycle, Organic Rankine Cycle, and Absorption Chiller

Feasibility Study of Scheme and Regenerator Parameters for Trinary Power Cycles

Performance enhancement of regenerative gas turbine: air bottoming combined cycle using bypass valve and heat exchanger—energy and exergy analysis

An Exergetic Analysis of New Thermodynamic Cycles Involving Carbon Dioxide Capture

Techno-Economic Efficiency Estimation of Promising Integrated Oxyfuel Gasification Combined-Cycle Power Plants with Carbon Capture

Gas turbine performance enhancement for naval ship propulsion using wave rotors

Techno-economic, techno-environmental assessments, and deep learning optimization of an integrated system for CO 2 capturing from a gas turbine: Tehran case study

Model-Based Thermodynamic Analysis of a Hydrogen-Fired Gas Turbine with External Exhaust Gas Recirculation