Position sensitive SiPM detector for Cherenkov applications

L. Gruber,G. S. M. Ahmed,S. E. Brunner,P. Bühler,J. Marton,K. Suzuki

DOI: https://doi.org/10.1088/1748-0221/6/11/C11024

2011-11-15

Abstract:A prototype of a position sensitive photo-detector with 5.6 x 5.6 cm2 detection area readout with 64 Hamamatsu MPPCs (S10931-100P) with 3 x 3 mm2 active area each has been built and tested. The photo-sensors are arranged in a 8 x 8 array with a quadratic mirror light guide on top. The module is currently readout by in-house developed preamplifier boards but employing existing ASIC chips optimized for SiPM readout is also planned. Such a device is one of the candidates to be used for photon detection in the PANDA DIRC detectors.

Instrumentation and Detectors,Nuclear Experiment

What problem does this paper attempt to address?

The problem that this paper attempts to solve is to develop a high - precision, position - sensitive photodetector based on silicon photomultiplier (SiPM) for detecting Cherenkov light in the DIRC detector in the PANDA experiment. Specifically, the main research problems include:

1. **Improve photon detection efficiency**: Use a position - sensitive SiPM array and a light concentrator to increase the number of incident photons and improve the signal - to - noise ratio.
2. **Replace existing technology**: Since the lifetime of micro - channel plate photomultiplier tubes (MCP - PMTs) is not sufficient to cope with the expected photon rate, the research aims to evaluate SiPM as an alternative to MCP - PMTs.
3. **Optimize design and performance**: Through experimental measurements and Monte Carlo simulations, optimize the design and performance of the light concentrator to ensure its efficient operation at low light intensities and achieve the required angular resolution (2 - 2.5 mrad).

### Specific objectives
- **Develop a prototype detector**: Construct a prototype detector with a detection area of 5.6 × 5.6 cm², consisting of 64 Hamamatsu MPPC (S10931 - 100P) in an 8 × 8 array, with each MPPC having an effective area of 3 × 3 mm².
- **Test the light concentrator**: Evaluate the influence of light concentrators with different coatings (such as aluminum and chromium) on photon collection efficiency.
- **Verify performance**: Verify the performance of the detector through laboratory laser scanning and beam - flow tests, and compare it with the simulation results.

### Key formulas
- **Geometric acceptance increase factor**:
\[
\text{Increase factor}=\left(\frac{7}{3}\right)^{2}\times\varepsilon_{\text{geo}}\approx5.1
\]
where \(\varepsilon_{\text{geo}} = 0.93\) is the geometric filling factor of the light concentrator.

- **Detection efficiency**:
\[
\varepsilon_{\text{detect}}=\varepsilon_{\text{col}}\times\varepsilon_{\text{PDE}}
\]
where \(\varepsilon_{\text{col}}=\frac{n_d}{N_{\text{phot}}}\) is the collection efficiency of the light concentrator, \(n_d\) is the number of photons reaching the exit, \(N_{\text{phot}}\) is the total number of photons hitting the entrance; \(\varepsilon_{\text{PDE}}\) is the photon detection efficiency of the light sensor.

Through these studies, the paper aims to provide an efficient and reliable light detection solution for the PANDA experiment.