Stepwise emergence of an intensive physical property from a single-atom to bulk

Jason N. Armstrong,Susan Z. Hua,Harsh Deep Chopra

DOI: https://doi.org/10.48550/arXiv.1110.4908

2011-10-22

Abstract:Intensive or size-invariant physical properties are well known to become size-dependent when the bulk material is reduced to the nanometer scale. Using silver, the present study shows a remarkable emergent characteristic of extensive properties as the size of the system is increased from a single atom to bulk - the property (strength) evolves in a staircase manner, as opposed to the intuitively assumed continuous approach to a saturating bulk value. In other words, the observed variation with size retains the inherent trait of intensive properties in the form of size-independent staircase plateaus. The steps can be explained by simple and necessary geometric configurations that atoms must assume in their initial approach to bulk. Were it not for these observations, it would have been remarkable to have reported that the observed strength in the limit of a single-atom Ag bridge approaches the theoretical limit, being 3-4 orders of magnitude higher than in bulk single crystals. The appearance of steps is acutely sensitive to minute perturbations, and their observation is enabled by pico-level resolution in measured forces and displacements in highly stable atomic sized bridges. However, suitably harnessed, results open the possibility to impart vastly different strengths to the same material based only on its size. This combined with possibility to change the position and height of the steps by mixing elements of different diameters and surface energy, opens a realistic approach to 'materials by design'. Results also provide an example of the evolutionary trace of an emergent physical property in materials.

Mesoscale and Nanoscale Physics

What problem does this paper attempt to address?

The problem that this paper attempts to solve is: how do the physical properties (especially strength) of materials evolve when they gradually expand from single atoms to bulk. Specifically, the author studied the strength change of silver (Ag) at the nanoscale and revealed that this change exhibits a step - like rather than continuous characteristic.

### Main problems:
1. **Step - like feature of strength change**:
- Traditionally, it is believed that when materials gradually increase from the nanoscale to the bulk, their physical properties such as strength will smoothly approach the bulk values. However, this study found that the strength of silver shows an obvious step - like change as the size increases.
- This step - like change indicates that at certain specific sizes, the strength of the material will change abruptly rather than continuously.

2. **Influence of geometric configuration**:
- Research shows that these step - like changes are determined by the geometric configuration of atoms at different sizes. For example, when the system expands from a single atom to multiple atoms, the arrangement of atoms will change significantly, resulting in a jump - like increase in strength.

3. **Influence of surface energy**:
- The change in the surface energy of silver between different crystal planes is small, which makes silver an ideal material for studying this phenomenon. In contrast, the surface energy of gold changes greatly, resulting in its strength change being less obvious than that of silver.

### Key formulas:
- The **Sharvin formula** is used to estimate the cross - sectional area of atomic configurations:
\[
G_{\text{Sharvin}}=\frac{2e^{2}}{h}\cdot\frac{A}{\lambda_{F}^{2}}
\]
where \( G_{\text{Sharvin}} \) is conductivity, \( e \) is the electron charge, \( h \) is Planck's constant, \( A \) is the cross - sectional area, and \( \lambda_{F} \) is the Fermi wavelength.

4. **Theoretical limit strength**:
- In the case of a single - atom bridge, the theoretical limit strength of silver is approximately \( 1.4\times 10^{10}\,\text{Pa} \), which is about four orders of magnitude higher than the yield strength of bulk silver (the yield strength of bulk silver is \( 0.5\times 10^{6}\,\text{Pa} \)).

Through these studies, the author demonstrated the unique behavior of materials at the nanoscale and proposed the possibility of designing materials with different strength characteristics by controlling the material size.