Abstract:Products and assets are becoming increasingly “smart”, e.g., mechatronic, electronic, or cyber-physical. In the lack of fully reliable wireless solutions, extensive wiring and wire bundling into wire harnesses are needed. This has manufacturing implications, leading to increasingly complex wire harness assembly processes, where numerous components, connectors, and cables are assembled, connecting critical and non-critical electric and electronic systems in smart products and assets. Thus, wire harnesses demand is rapidly rising in most industries, requiring human or robotic work. Often, required work tasks are repetitive and physically demanding, while still needing people for quality reasons. An attractive solution would therefore be humans collaborating with robots. Unfortunately, there are very few scientific studies on automation solutions using collaborative robots (cobots) for wire harness assembly process tasks to increase process productivity and improve work ergonomics. Furthermore, wire harness assembly process tasks are presently carried out 90% manually in this industry, causing serious ergonomic problems for assembly workers who perform such tasks daily. The challenge is reducing the ergonomic risks currently present in many established wire harness assembly processes while improving production time and quality. This paper presents an early prototype and simulation to integrate a cobot into a wire harness assembly process, primarily for work ergonomic improvements. The use of a cobot is specifically proposed to reduce ergonomic risks for wire harness assembly workers. Two methodologies: RULA and JSI were used to evaluate the ergonomics of the task of cable tie collocation. The real-world case study results illustrate the validation of a cobot which significantly reduced non-ergonomic postures in the task of placing cable ties in the wire harnesses assembly process studied. An ergonomic analysis without the cobot (the actual process) was conducted, based on RULA and JSI methodologies, presenting the highest possible scores in both evaluations, which calls for urgent changes in the current wire harness assembly process task studied. Then, the same analysis was performed with the cobot, obtaining significant reductions in the ergonomic risks of the task at hand to acceptable values.

Enhancing ergonomics in E-waste disassembly: the impact of collaborative robotics on muscle activation and coordination

The assistance of BAZAR robot promotes improved upper limb motor coordination in workers performing an actual use-case manual material handling

Design of an Energy-Aware Cartesian Impedance Controller for Collaborative Disassembly

A Review of Prospects and Opportunities in Disassembly with Human-Robot Collaboration

Towards Reuse and Recycling of Lithium-ion Batteries: Tele-robotics for Disassembly of Electric Vehicle Batteries

Development of an ergonomic wearable robotic device for assisting manual workers

Wire Harness Assembly Process Supported by a Collaborative Robot: A Case Study Focus on Ergonomics

Computational ergonomics for task delegation in Human-Robot Collaboration: spatiotemporal adaptation of the robot to the human through contactless gesture recognition

Robotic disassembly for end-of-life products focusing on task and motion planning: A comprehensive survey

Design of Human-Centered Collaborative Assembly Workstations for the Improvement of Operators’ Physical Ergonomics and Production Efficiency: A Case Study

Human Robot Collaboration for Enhancing Work Activities.

Improving Workers' Musculoskeletal Health During Human-Robot Collaboration Through Reinforcement Learning

Human–Robot Collaboration on a Disassembly-Line Balancing Problem with an Advanced Multiobjective Discrete Bees Algorithm

Human-oriented design of collaborative robots

Walking and scuba diving assisted amphibious exoskeleton robots: the designing of power assist control and myoelectricity based wearers' fatigue evaluation

Revolutionizing Battery Disassembly: The Design and Implementation of a Battery Disassembly Autonomous Mobile Manipulator Robot(BEAM-1)

Electric Vehicle Battery Disassembly Using Interfacing Toolbox for Robotic Arms

Multi-objective optimisation for cell-level disassembly of waste power battery modules in human-machine hybrid mode

Human-robot collaboration in disassembly for sustainable manufacturing

NEXT-GENERATION COLLABORATIVE ROBOTIC SYSTEMS FOR INDUSTRIAL SAFETY AND HEALTH

An Ontology and Rule-Based Method for Human–robot Collaborative Disassembly Planning in Smart Remanufacturing