Intelligent Modeling and Design of a Novel Temperature Control System for a Cantilever-Based Gas-Sensitive Material Analyzer

Tianhai Lu,Chao Fei,Lin Xuan,Haitao Yu,Dacheng Xu,Xinxin Li

DOI: https://doi.org/10.1109/access.2021.3051339

IF: 3.9

2021-01-01

IEEE Access

Abstract:Devices used to set and control the environmental temperature are critical to the performance of gas-sensitive material analyzers, which use silicon microcantilevers to characterize the gas-sensitive materials. This paper describes a novel microtemperature-control device that uses a double Peltier structure to replace the traditional refrigerant temperature control system. A proportional-integral-derivative (PID) algorithm is used to achieve accurate and fast temperature control, with a long short-term memory (LSTM) network trained to identify the nonlinear dynamics of the Peltier system. A neighbor hybrid mean center opposition-based learning particle swarm optimization (NHCOPSO) algorithm is proposed to optimize the PID controller. The LSTM network identification is obviously better than that of previous Peltier system identification methods, and the NHCOPSO algorithm is found to be superior to other improved PSO and evolutionary algorithms on benchmark functions and in PID parameter optimization. Experimental results show that the proposed temperature control device greatly improves the accuracy and efficiency of gas-sensitive material analysis with a temperature control range of −40 to 180°C, a temperature control tolerance within ±0.05°C, a maximum heating rate of 20°C/min, and a maximum cooling rate of −10°C/min.

computer science, information systems,telecommunications,engineering, electrical & electronic

What problem does this paper attempt to address?

### Problems Addressed by the Paper

This paper aims to address the issue of temperature control in the analysis of gas-sensitive materials. Specifically:

1. **Problems with Existing Temperature Control Systems**:
- Traditional refrigeration systems (such as mechanical refrigerants) are bulky, have slow temperature change rates, and poor temperature control accuracy.
- Liquid nitrogen refrigeration systems, although capable of achieving a wide temperature range (-50°C to 150°C), are large, have slow temperature change rates (3°C/min), low temperature control accuracy (±2.5°C), and are difficult and costly to maintain.

2. **Proposed New Solution**:
- Developed a new micro temperature control device based on the Peltier effect for silicon microcantilever gas-sensitive material analyzers.
- Utilized a dual-layer Peltier structure to replace traditional refrigerant temperature control systems, improving temperature control accuracy and efficiency.
- Employed Long Short-Term Memory (LSTM) networks to identify the nonlinear dynamic characteristics of the Peltier system and optimized PID controller parameters using the Neighbor Hybrid Center Opposition-Based Learning Particle Swarm Optimization (NHCOPSO) algorithm.

3. **Expected Outcomes**:
- The new temperature control device achieves a temperature control accuracy of ±0.05°C within a temperature range of -40°C to 180°C, with a maximum heating rate of 20°C/min and a maximum cooling rate of -10°C/min.
- Experimental results indicate that this temperature control device significantly improves the accuracy and efficiency of gas-sensitive material analysis.

In summary, this paper primarily addresses a series of issues with existing temperature control systems in the analysis of gas-sensitive materials, including large size, slow temperature change rates, and low temperature control accuracy. By introducing new technology based on the Peltier effect, higher precision and more efficient temperature control are achieved.