Abstract:The solid electrolyte interface (SEI) plays a crucial role for the performance and lifetime of lithium-ion batteries. It consists of decomposition products from electrolyte components (salt, solvent and additives) and is initially formed during the first charging process called the formation cycle. The chemical processes creating the SEI are a matter of current research. A better understanding of these reactions and their implications on cell performance can provide new ways to optimise the formation process. This can help reducing costs while increasing lifetime and performance of lithium-ion batteries. In this contribution we apply statistical correlation analysis on a large set of cells to gain new insights on the connection between formation and cell-performance. Cells (NMC622|Graphite, 1 Ah, ordered from LiFun) are divided in three groups. The groups differ only by the electrolyte. An electrolyte solution with EC:EMC (3:7 by wt.) and 1 M LiPF 6 serves as a baseline. The other two groups use the same solvent and salt concentration but contain an additional 5% fluor ethylene carbonate and vinylene carbonate, respectively. All cells underwent the same formation procedure. It consists of a formation cycle with C/5 at 80°C, followed by a degassing-step and 9 subsequent cycles with the same current rate at 45°C. After these ten cycles a reference performance test (RPT) is conducted, including qOCV, capacity and pulse-resistance tests. During the degassing step gas samples from half of the cells were analysed using GC-MS. An incremental capacity analysis of the formation cycle shows clear distinctions between the three different electrolytes. Distinct peaks below 3 V are found for each group. The gas composition demonstrates that cells containing additives contain a higher share of carbondioxide and carbonmonoxid amid a substantially lower share of ethylene, compared to the cells without additives. The large number of over 100 cells in total enables a systematic correlation analysis. We investigated the correlation between features extracted from the first formation cycle and the RPT. In addition, correlations between electrical data from the first cycle and the relative amount of carbon-containing gasses in the samples are analysed. Correlations differ for the three groups of cells, however some common trends were observed. We found a negative correlation between the average voltage during formation and the difference between the capacity of the first discharge and the capacity measured in the RPT. This difference represents the loss over the 9 cycles at 45°C. It is positively correlated with the first discharge capacity indicating that lower lithium-losses in the first cycle are countered by higher losses in subsequent cycles. Correlations between gasses and electrical data from the formation cycle provide new insights into the chemical processes. If the shares of two gasses are positively correlated, we assume that the reactions producing these gasses are linked. We found such strong positive correlations for the shares of CH 4 , C 2 H 6 , C 2 H 4 and CO in the case of VC-containing electrolyte. In this group the share of carbondioxide is negatively correlated to these gas-shares. Correlating the different gas-shares with the charge throughput in different voltage windows (during wetting at 1.5V, during the formation charge cycles from 1.5 to 3V, 3 to 3.8V, and 3.8 to 4.2 V, respectively), we found very different patterns for the three groups. VC-containing cells show weak or very weak correlations with all four charge-throughput values, with the exception of a moderate negative correlation between CO. Cells without additives show a moderate correlation between the wetting charge and the CO 2 -share. Cells containing FEC exhibit a moderate positive correlation between the share of CO 2 and the charge throughput between 1.5 and 3.8 V. The combination of electrical data with the gas composition and statistical analysis provides a new way to improve our understanding of the SEI formation and the complex chemical reactions. Our results indicate that gasses generated by the decomposition of VC are not influenced by small changes of charge throughput during formation, whereas a higher charge-throughput at lower voltages in cells containing FEC correlates with an increased share of CO 2 .

A Coupled NMR and Differential Capacity Study of the Consumption of Electrolyte and Additive Components during the Formation Cycle of Li-Ion Pouch Cells

Chemometric and Machine Learning Analysis of Lithium Concentration and Solvation Behavior in Li-Ion Battery Electrolytes

Study of Electrolyte Components in Li Ion Cells Using Liquid-Liquid Extraction and Gas Chromatography Coupled with Mass Spectrometry

Modulation and quantitative study of conformal electrode-electrolyte interfacial chemistry toward high-energy-density LiNi0.6Co0.2Mn0.2O2‖SiO-C pouch cells

Correlating Gas Composition and Electrochemical Data from First Formation Cycle of Lithium-Ion Batteries

Optimization of electrolyte volume in lithium-ion pouch-type cells

Tuning the Interface Stability of Nickel-Rich NCM Cathode Against Aggressive Structural Collapse via the Synergistic Effect of Additives

Coupling liquid electrochemical TEM and mass-spectrometry to investigate electrochemical reactions occurring in a Na-ion battery anode

A Consideration of Electrolyte Additives for Lini0.5mn1.5o4/Li4ti5o12 Li-Ion Cells

Coupling Liquid Electrochemical TEM and Mass‐Spectrometry to Investigate Electrochemical Reactions Occurring in a Na‐Ion Battery Anode

A Universal Plug-and-Play Approach to In Situ Multinuclear Magnetic Resonance Analysis of Electrochemical Phenomena in Commercial Battery Cells

Cycling Performance of NMC811 Anode-Free Pouch Cells with 65 Different Electrolyte Formulations

Importance of Reduction and Oxidation Stability of High Voltage Electrolytes and Additives

Magnetic Force Dilatometry of Silicon-NMC622 Lithium-Ion Coin Cells: The Effects of Binder, Capacity Ratio, and Electrolyte Selection

Quantification of the Li-ion Diffusion over an Interface Coating in All-Solid-state Batteries Via NMR Measurements

Tuning the End Alkyl Chain of the Ether Solvent to Stabilize the Electrode/Electrolyte Interfaces in the NCM-Li Battery

How do Depth of Discharge, C-rate and Calendar Age Affect Capacity Retention, Impedance Growth, the Electrodes, and the Electrolyte in Li-Ion Cells?

A bicomponent electrolyte additive towards stabilized interface for high-performance lithium-ion batteries

Investigation of The Failure Mechanisms of Li-Ion Pouch Cells with Si/Graphite Composite Negative Electrodes and Single Wall Carbon Nanotube Conducting Additive

Influence of Carbonate Electrolyte Solvents on Voltage and Capacity Degradation in Li‐Rich Cathodes for Li‐ion Batteries

Quantitative elucidation of cathode reaction mechanisms in Li-O2 batteries within high donor number solvents