Developing Porcine Acellular Dermal Matrix by Using Sodium Dodecyl Sulfate and Biomechanical Property Testing

Medisa Primasari,Iswinarno Doso Saputro,Lynda Hariani,Glorian Paul Bosco Velusamy
DOI: https://doi.org/10.4103/bhsj.bhsj_2_24
2024-05-23
Biomolecular and Health Science Journal
Abstract:A BSTRACT Introduction: An alternative for supporting wound closure is acellular dermal matrix (ADM), which serves as a scaffold. Humans and porcine possess a similar biochemical makeup. Using sodium dodecyl sulfate (SDS), a decellularization technique was developed and its biomechanical properties were assessed. Methods: This work uses a pig dermis layer for an in vitro experimental investigation with a posttest-only control group. Using SDS 0.5% for 14 days, the decellularization procedure compares the biomechanical properties and cellular components of the ADM with control. The Mann–Whitney U -test for data with a nonnormal distribution or the t -test for continuous variables with a normal distribution was used for the study. Results: Histological analysis revealed that none of the cells were detected in four fields of analysis in the treatment group; however, 48.00 ± 4.86 cells were observed in the control group ( P < 0.001); the collagen organization in the control group appeared to be identical. The variables elastic modulus (MPa) (136.78 vs. 129.19; P = 0.556), thickness (mm) (3.27 vs. 3.15; P = 0.397), and width (mm) (8.50 vs. 8.56; P = 0.40) did not differ statistically. The following data showed significant differences between the treatment group and the control group: break strain (%) (108.46 vs. 67.48; P < 0.001) and tensile strength stress (MPa) (19.916 vs. 22.1; P = 0.030). Conclusions: SDS decellularization is an efficient method for creating an ADM. Although the break strain was considerably lower, the treatment group’s tensile strength was higher. Elastic modulus changes were not observed.
What problem does this paper attempt to address?