Abstract:Abstract Mathematical models can be successfully applied to predict the multi-effect distillation system integrated with thermal vapour compression unit (MED-TVC) performance under different operating conditions. In this work, a one-dimensional (1-D) mathematical model was developed to perform the theoretical analysis of a small-scale parallel feed MED-TVC desalination system driven by solar heat. A parametric study was conducted allowing the ejector motive steam temperature, first effect temperature, between effects temperature difference and ejector compression ratio to vary within an expectable range. The results showed that higher motive steam temperatures, had a positive impact on the water yield up to an optimal point. Any additional increase of driving steam temperature reduced water yield. Gain output ratio ($GOR$) was maximum at the highest considered motive temperature. It was found that the calculated specific heat transfer area does not depend on the motive temperature variation. Water yield, $GOR$ and specific heat transfer area decrease with the ejector compression ratio. The temperature difference between the evaporator effects had no effect on the water yield and $GOR$. It only decreases the specific heat transfer area. First effect temperature should be as low as possible with respect to operational constraints. Based on the parametric study, the optimal design operating conditions, corresponding to the maximum water yield is identified for a small-scale three-effect desalination system. The unit can produce up to 204 l/h drinking water with a gain output ratio of 8.6 and specific heat transfer area of 575 m2/kg/s using about 22 kW of solar heat.

Analysis of the Effectiveness of Condenser Heat Transfer in the Distillation Process of Serai Wangi Leaves

The Flow Rate of the Condenser Cooling Water in the Distillation Process Increases the Quality and Quantity of Patchouli Oil

Thermal analysis and performance investigations of shell and tube heat exchanger using numerical simulations

Heat and mass transfer analysis and optimization of passive interfacial solar still

Optimized Liquid-Separated Thermodynamic States for Working Fluids of Organic Rankine Cycles with Liquid-Separated Condensation

Numerical Analysis of Air-Water Heat Exchanger as Passive Cooling System in Air Ventilation

Effect of Compressor-Discharge-Cooler Heat-Exchanger Length Using Condensate Water on the Performance of a Split-Type Air Conditioner Using R32 as Working Fluid

Experimental and numerical performance of a multi-effect condensation–evaporation solar water distillation system

Design and Analysis of Exhaled Breath Condenser System for Rapid Collection of Breath Condensate

Numerical simulation of condensation from isobutane vapour – air mixture

Thermodynamic analysis and performance assessment of different feed configurations for solar multi-effect distillation plant

Using the Log Mean Temperature Difference (LMTD) and ε-NTU Methods to Analyze Heat and Mass Transfer in Direct Contact Membrane Distillation

The impact of wettability on the performance of a two row wavy fin and tube liquid desiccant system for dehumidification and regeneration

Research on the Performance and Computational Fluid Dynamics Numerical Simulation of Plate Air Gap Membrane Distillation Module

Improving the Heat Transfer Rate of Air Conditioning Condenser by Material Optimization

Effect of compressor discharge cooling using condensate on performance of residential air conditioning system

Theoretical performance assessment of a multi-effect distillation system integrated with thermal vapour compression unit running on solar energy

Condensing heat transfer performance in small-diameter enhanced tubes of absorption refrigeration system: An experimental investigation

Experimental Study on the Composition Evolution and Selective Separation of Biomass Pyrolysis Vapors in the Four-Staged Indirect Heat Exchangers.

Performance of an Air-Cooled Heat Exchanger in a Separation Unit Based on Fouling Factor and Pressure Drop

Modeling of a MED-TVC desalination system by considering the effects of nanoparticles: energetic and exergetic analysis