Abstract:A single-cylinder marine diesel engine was modified to be operated in reactivity controlled compression ignition (RCCI) combustion mode. The engine fueling system was upgraded to a common rail fuel injection system. Natural gas (NG) was used as port fuel injection, and a diesel/sunflower methyl ester biodiesel mixture was used for direct fuel injection. The fraction of biodiesel in the direct fuel injection was changed from 0% (B0; 0% biodiesel and 100% diesel) to 5% (B5) and 20% (B20) while keeping the total energy input into the engine constant. The objective was to understand the impacts of the increased biodiesel fraction on the combustion characteristics and stability, emissions, and knocking/misfiring behavior, keeping all other influential parameters constant. The results showed that nitrogen oxides (NOx) emissions of B5 and B20 without the need for any after-treatment devices were lower than the NOx emission limit of the Euro VI stationary engine regulation. B5 and B20 NOx emissions decreased by more than 70% compared to the baseline. Significantly more unburned hydrocarbons (UHCs) and carbon monoxide (CO) emissions were produced when biodiesel was used in the direct fuel injection (DFI). The results also showed that using B5 and B20 instead of B0 led to an increase of 18% and 13.5% in UHCs and an increase of 88.5% and 97% in CO emissions, respectively. Increasing the biodiesel fraction to B5 and B20 reduced the maximum in-cylinder pressure by 3% and 10.2%, respectively, compared to B0. Combustion instability is characterized by the coefficient of variation (COV) of the indicated mean effective pressure (IMEP), which was measured as 4.2% for B5 and 4.8% for B20 compared to 1.8% for B0. Therefore, using B20 and B5 resulted in up to 34.9% combustion instabilities, and 18.5% compared to the baseline case. The tendency for knocking decreased from 13.7% for B0 to 4.3% for B20. The baseline case (B0) had no misfiring cycle. The B5 case had some misfiring cycles, but no knocking cycle was observed. Moreover, the historical cyclic analysis showed more data dispersions when the biodiesel fraction increased in DFI. This study shows the potential of biodiesel replacement in NG/diesel RCCI combustion engines. This study shows that biodiesel can be used to effectively reduce NOx emissions and the knocking intensity of RCCI combustion. However, combustion instability needs to be monitored.

Combustion Characteristics of a Variable Compression Ratio Diesel Engine Using Hibiscus Cocos nucifera Biodiesel and Taguchi Optimization

An experimental investigation of performance and emission of thumba biodiesel using butanol as an additive in an IDI CI engine and analysis of results using multi-objective fuzzy-based genetic algorithm

Overall Performance Investigation and Optimization of a Multi-fuel Operated Compression Ignition Engine Using Coupled Taguchi and Grey Relational Analysis

Combustion Characteristics of A Diesel Engine Operated with Diesel and Burning Oil of Biomass

Multi-objective Performance Optimization of Compression Ignition Engine Operated on Mangifera Indica Biodiesel by Applying Taguchi Grey Relational Analysis

Experimental Analysis of Hydrogen Addition at Varying Injection Opening Pressures on a Dual-Fuel Diesel Engine Operating with Diesel and Cottonseed Oil

Combustion exhaust release impact, diesel engine performance, and optimization studies of green diesel-petrodiesel blend in a high compression ratio direct-injection compression-ignition engine

Optimization of Combustion Characteristics of Diesel Engine Fueled by Biofuels and Its Diesel Blends with Additive Titanium Dioxide Nano-Particles

Optimization of biodiesel/2-propanol/1-hexanol blends based on diesel engine performance using combined mixture-process design (CMPD)

Combustion characteristics of CI engine fueled with WCO biodiesel/diesel blends at different compression ratios and EGR

Impact of hydrogen-assisted combustion in a toroidal re-entrant combustion chamber powered by rapeseed oil/waste cooking oil biodiesel

Performance analysis and optimization of thermal barrier coated piston diesel engine fuelled with biodiesel using RSM

Optimization of ideal engine parameters to adopt ammonia and algae biodiesel for reactivity controlled compression ignition engine using response surface methodology

Comparative thermal assessment and emission analysis of various green biodiesel from novel feedstocks for CI engines: a sustainable approach towards emission reduction

A novel experimental performance and emission study on CRDI engine using hydrogenated and green biodiesels: A turbo powered engine with hydrogen dual fuel and ANN prediction approach

Effective utilization of tobacco (Nicotiana Tabaccum) for biodiesel production and its application on diesel engine using response surface methodology approach

Prediction and optimization of engine characteristics of a DI diesel engine fueled with cyclohexanol/diesel blends

Experimental Study the Effect of Injection Strategies on Combustion and Emission Characteristics in Gasoline Compression Ignition Engines Using Gasoline/hydrogenated Catalytic Biodiesel Blends

Detailed Analysis of the Effects of Biodiesel Fraction Increase on the Combustion Stability and Characteristics of a Reactivity-Controlled Compression Ignition Diesel-Biodiesel/Natural Gas Engine

Numerical simulation of the combustion chamber and performance analysis of microalgae-based biodiesel/diesel-powered CI engine: An axisymmetric flow approach

Performance and CO2 emission of a single cylinder compression ignition engine powered by Khaya senegalensis non-edible seeds fuel blends