Abstract:Excessive exposure to noises, which corresponds to unwanted and/or unpleasant sounds, poses as a threat to people's health and can cause irritability, insomnia and even hearing loss. To attenuate noises, sound absorbers usually composed of porous materials are widely used. These, which appear as large networks of interconnected pores, are capable of absorbing medium and high sound frequencies, specially, transforming into heat the majority of the sound energy that reaches them. Such dissipations occur due to viscous, thermal and inertial losses resulted from interactions between the solid and fluid phases from which the porous materials are composed of. With the growing demand for acoustic comfort, one of the most important topics in noise control engineering is currently the search for sound absorption materials that provide attenuations in wide frequency ranges with minimum cost, weight and thickness. Fiberglass wool and melamine foam are widely used, and a variety of new porous materials are being developed, such as polymer micro- and nanofiber mats obtained by electrospinning. It is here investigated the acoustic potential of the electrospun polycaprolactone (PCL) fiber mat, normally used as a biomaterial. The sound absorption capacity of a material is given by its sound absorption coefficient ( α ), while its sound insulation capacity is denoted by its transmission loss (TL), and these are normally conflicting. In an impedance tube, through the transfer function and the transfer matrix methods, α and TL curves are here determined for samples of fiberglass wool and melamine foam with 25 mm width, and later these combined with a layer of approximately 0.3 mm of PCL fiber mat. With the addition of a fine layer of those polymeric fibers to both base materials, it was observed expressive gains in the sound absorption and transmission loss potentials in almost all the totality of the frequency range analyzed, which extends from 400 to 2500 Hz. It was also analyzed the morphology of the study materials through Scanning Electron Microscopy (SEM), and their porosities were determined through an optical approach with the aid of X-ray microtomography.

Modeling a low-frequency sound absorber consisting of a granular activated carbon stack backed by a poro-elastic layer

Granular activated carbon sound absorption predictions made using measured material parameters

A poro-elastic model of sound propagation in granular materials

Low-frequency broadband sound absorption of the metastructure with extended tube resonators and porous materials

Designing hybrid aerogel-3D printed absorbers for simultaneous low frequency and broadband noise control

Sound absorption performance based on Auxetic microstructure model: a parametric study

Multilayer structures for high-intensity sound energy absorption in low-frequency range

Ultra-broadband sound absorption of a multiple-cavity metastructure with gradient thickness

A Novel Multiscale Porous Composite Structure for Sound Absorption Enhancement

Gradually Perforated Porous Materials Backed with Helmholtz Resonant Cavity for Broadband Low-Frequency Sound Absorption

A Composite Structure for Low-Frequency Sound Absorption With Continuous Broadband Under High Sound Pressure Excitations

Enhanced Low-Frequency Sound Absorption of a Porous Layer Mosaicked with Perforated Resonator

A Semi-Empirical Model for Sound Absorption by Perforated Plate Covered Open Cell Foam and Improvements from Optimising the Perforated Plate Parameters

Coiled-up Structure with Porous Material Lining for Enhanced Sound Absorption

Acoustic Metaporous Layer with Composite Structures for Perfect and Quasi-Omnidirectional Sound Absorption

Optimization of the Acoustic Performance of a Composite Multi-cell Sound Absorber

Sound Absorption Characteristics of Multilayer Porous Metal Materials Backed with an Air Gap

A novel membrane-cavity-grating (MCG) meta-structure for enhancing low-frequency sound absorption

A Multiscale Theoretical Approach for the Sound Absorption of Slit-Perforated Double Porosity Materials

Ventilated metasurface absorber constructed by synthesized acoustic multipoles

Optimizing Acoustic Performance: Electrospun Polycaprolactone Fiber Mat Associated with Melamine Foam and Fiber Glass Wool