Abstract:At present, there is a great interest in the development of new airfoils for wind turbines and high-lift wings of unmanned aerial vehicles (UAV). The requirements for such airfoils differ from conventional aircraft airfoils, because of structural reasons and extreme operating conditions. So, wind turbine airfoils operate frequently under fully separated flow when stall is used for power regulation at high wind speeds. At the same time design of airfoils for wings UAV poses the problem of availability of high-lift at low Reynolds number. Modern airfoils are to a large extent developed from numerical methods. However, the complex flow conditions such as separation at high angles of attack, laminar separation bubbles and the transition from laminar to turbulent flow are difficult to predict accurately. Hence, testing of airfoils at a two-dimensional condition is an important phase in airfoil design. The development and validation of a 2D testing facility for investigation of single and multi-element airfoils in the wind tunnel Т-102 with open test section are considered in this article. T-102 is a continuous-operation, closed-layout wind tunnel with two reverse channels. The test section has an elliptical cross-section of 4 ×2,33 m and a length of 4 m. Two big flat panels of the L × H=3 ×3,9 m size installed upright on balance frame aligned with the free stream are used for simulating two-dimensional flow in the tunnel test section. The airfoil section in the layout of a rectangular wing is mounted horizontally between flat panels with minimum gaps to ensure 2D flow conditions. The aerodynamic forces and pitch moment acting on the model were measured by wind tunnel balance. To determine boundary corrections for a new test section of wind tunnel, the experimental investigation of three geometrically similar models has been executed. The use of boundary corrections has provided good correlation of the test data of airfoil NACA 6712 with the results obtained from the wind tunnel except for lift and drag coefficient values at high angles of attack.

Solution of the Problem of Identification of Aerodynamic Coefficients of Aircraft According to the Data of Their Full-Scale Tests

Identification of Engine Thrust and Aerodynamic Drag Force According to Flight Test Data with Smoothing of Random Measurement Errors

Reliable method of aerodynamic analysis using computational fluid dynamics and scaled models in the development process of a Very Light Airplane

THE CALCULATION AERODYNAMIC CHARACTERISTICS OF A HYBRID AEROSTATIC AIRCRAFT

Study of sports car aerodynamics using computer simulation methods

Unsteady Aerodynamic Identification of Aircraft at High Angles of Attack

Calculation And Identification Of The Aerodynamic Parameters For Small-Scaled Fixed-Wing Uavs

Numerical Evaluation of Aircraft Aerodynamic Static and Dynamic Stability Derivatives by a Mid-Fidelity Approach

Progressive Identification of Lateral Nonlinear Unsteady Aerodynamics from Wind Tunnel Test Data.

Static and fatigue testing using the same full-scale transport aircraft structure

Conception of developing the dynamically similar downscaled medium-range passenger airplane model for in-flight testing

Towards Structural and Aeroelastic Similarity in Scaled Wing Models: Development of an Aeroelastic Optimization Framework

AERODYNAMIC INTERACTION SIMULATION DURING TRACK TESTING OF AIRCRAFT PRODUCTS

Aeroelastic Response Analysis of a Coupled Rotor/Fuselage System ( II ) Solution of the Equations

Scaling Function Learning: A sparse aerodynamic data reconstruction method for generalizing aircraft shapes

A Method for Evaluation of Aerodynamic Lift and Drag Based on Statistical Mechanics

Investigation of the Influence of the Chemical Composition of the Air Environment on the Flight Aerodynamics of Small Aircrafts

Discrete integration for measuring aerodynamic loads on trains in crosswinds − realizable strategies of discretization and discrete integration

SIMULATION OF 2D FLOW AROUND OF AIRFOILS AT LOW-SPEED WIND TUNNEL WITH OPEN JET TEST-SECTION

Analytic Solutions for Volume, Mass, Center of Gravity, and Inertia of Wing Segments and Rotors of Constant Density

Combined Static and Fatigue Tests of the Full-Scale Structure of a Transport Aircraft