Abstract:Nowadays, every single distribution system needs to install an appropriate relay to keep the system safe. The operational and commonly recommended relay for distribution systems is the overcurrent (OC) relay. Throughout the distribution system, the protective relay is one of the methods that can detect and protect the location according to its observation from any fault from abnormal activity. Note that time coordination between the protective equipment relay needs to be a minimum of time interruption to prevent faults occurs. The ideal setting for all coordination protection relays is necessary to protect the device against electrical failure and interference. This paper analyzes the real results data collected for the selected commercial building of an OC relay implemented in a distribution board for high voltage and low voltage downward at a commercial building. All the parameters need to be clarified first before testing has been made and measurement is carried out using the MICROTEST 860 set. Based on the analysis, it proves that according to the IEC Standard of 0.10-time multiplier Setting (TMS) is practical to be used to obtain the operation time in seconds for the current curve set. Other than that, the results show that the normal inverse curve from manual calculation results is more accurate compared to the service setting (SS) made based on the incoming setting in a real commercial building. The case study for OC relay setting is related between current injection and time-tripping, which complies with the IEC 60255-3 standard using its formula. This method was applied to determine the characteristics of the curve. Hence, this research successfully determined the proper methods for the OC relay setting for the power distribution system. Besides, the feasibility and efficiency of OC relay data transmission are tested and checked successfully to implement the measurement method in the relay coordination study.

Feasibility and Performance Evaluation of Microprocessor and Fuzzy Logic-Based Overcurrent Relay in Electrical Protection Systems

Design and Implementation of Overcurrent Protection Relay

Design and Implementation of Multifunction Relay Based on Microcontroller

Protection Relay Setting based on Overcurrent Phenomena in Commercial Building

Modelling and Implementation of Microprocessor Based Numerical Relay for Protection Against Over/Under Current, Over/Under Voltage

Design and Development of Overcurrent Protection Relay Inverse Definite Minimum Time Type Based on Arduino Uno

Recognition of Electric Machines Boundary as The Constraint of Over Current Relay Coordination in Real Industrial Application with Serial Firefly Algorithm Optimization

ANALISA PROTEKSI OVER CURRENT RELAY (OCR) DAN GROUND FAULT RELAY (GFR) PADA TRANSFORMATOR DAYA GARDU INDUK

Autonomous Overcurrent Relay Protection Coordination by AI and IoT Technology

Relay protection devices functionality comparative analysis

Optimizing directional overcurrent relay coordination with jellyfish search algorithm

Design and Construction of Thermal Overload Relay (Siemens 3ua50) Based on Arduino Uno

Determination of the speed of a microprocessor relay protection device of open architecture with a reed switch and the industrial internet of things

Short-Circuit and Over-Current Fault Detection for SiC MOSFET Modules Based on Tunnel Magnetoresistance with Predictive Capabilities

The research and application on interfacing technology between Electronic Current Transformer and relay protection

An Adaptive Overcurrent Protection for Solar-based DC Microgrids Using IEC 61850

Hybrid GA-IPM algorithm for optimal protection coordination of directional overcurrent relays with mixed time current characteristic curves

The Protection Relay Coordination Studies (Over Current Relays and Ground Fault Relays) On The Power Plant Electrical System, PT. Rekind Daya Mamuju By Using The ETAP 12.6 Program

Distribution Transformer Protection and Automatic System Using PLC

Adaptive protection scheme for microgrids

Enhancing resilience of advanced power protection systems in smart grids against cyber–physical threats