Abstract:Combustion technologies require gas sensors for monitoring and controlling the exhaust and to meet increasingly stringent environmental regulations. NOx compounds (NO and NO2) in diesel exhaust can lead to poor air quality and act as both pollutants and greenhouse gases. Aftertreatment strategies have been developed to mitigate NOx and usually require information about the NOx sensor output. The design and operation of aftertreatment strategies rely on an understanding of sensor behavior and deviations. However, sensor specifications provided by suppliers typically only reflect the minimum requirements necessary to meet basic application needs. Supplier information about sensor performance can therefore be too general whereas more detailed information could allow more flexibility and potentially cost savings during early development of the overall aftertreatment system and strategy. The approach and application of a methodology for predicting nominal sensor output and standard deviation is presented. The prediction is in the form of an empirical NOx sensor performance model that relies on experimental data for a specified population of sensors. Inputs include the concentration of exhaust components (e.g., NO, NO2, O2, etc.), physical state (e.g., temperature, pressure, etc.), as well as additional information about sensor condition and location (e.g., as-received brand-new sensors, tailpipe position, etc.). The output would be a dynamic real-time estimate for the NOx sensor broadcast signal and standard deviation for the defined population. Experimental data are primarily collected using a laboratory high-flow test bench that simulates exhaust conditions. We present an approach that includes understanding exhaust conditions to determine the initial factors of interest as well as reasonable ranges of values for those factors. We then investigate the correlation of the factors with the measured error of the NOx sensor broadcast value using a design of experiments (DOE) response surface methodology (RSM) with ten factors. The population was defined as nine as-received brand-new NOx sensors tested simultaneously in the laboratory high-flow test bench. Least squares fitting with a linear regression model seemed to adequately describe the correlation of mean sensor signal shifts with changes in the ten factors. Methods for validation of the model and planned next steps are discussed.

A semi-empirical model for online real-time control of NOX generation in diesel engines

On the Use of Artificial Neural Networks to Model the Performance and Emissions of a Heavy-Duty Natural Gas Spark Ignition Engine

Development of a semi-empirical physical model for transient NOx emissions prediction from a high-speed diesel engine

Prediction of Transient NOX Emission from a Non-Road Diesel Engine Using a Model Combining Bayesian Search and Population-based Training

Development of a Real-Time NOx Prediction Model Based on Heat Release Analysis in a Direct-Injection Diesel Engine

Research on Input Parameter Optimization for NOx Deep Learning Prediction Model

The Prediction of Fuel Injection Quality Using a NOx Sensor for the On-Board Diagnosis of Heavy-Duty Diesel Engines with SCR Systems

An Improved NO Prediction Model for Large Eddy Simulation of Turbulent Combustion

An Artificial Neural Network Model to Predict Efficiency and Emissions of a Gasoline Engine

Development of a NOx Calculation Model for Low-Speed Marine Diesel Engines Based on Soft Measurement Technology

Real-time NOx estimation in light duty diesel engine with in-cylinder pressure prediction

A Deep Transfer NOx Emission Inversion Model of Diesel Vehicles with Multisource External Influence

A Novel Deep Learning Approach to Predict the Instantaneous NOx Emissions From Diesel Engine

Super-learner model realizes the transient prediction of CO2 and NOx of diesel trucks: Model development, evaluation and interpretation

NO and NO2 Concentration Modeling and Observer-Based Estimation Across a Diesel Engine Aftertreatment System

Prediction of CO and NOx Emissions from Automotive Engines Based on Machine Learning Algorithms

Research on Actual Road Emission Prediction Model of Heavy-Duty Diesel Vehicles Based on OBD Remote Method and Artificial Neural Network

Predicting the Nitrogen Oxides Emissions of a Diesel Engine using Neural Networks

Improved NO and NO2 Concentration Estimation for a Diesel-Engine-Aftertreatment System

A NOx Emission Model Incorporating Temperature for Heavy-Duty Diesel Vehicles with Urea-SCR Systems Based on Field Operating Modes

(Digital Presentation)Empirical Methods for Modeling NOx Sensor Performance Errors in Combustion Applications