Abstract:Retention indices are values that characterize the retention of a compound in gas chromatography. In practice, retention indices are often assumed to depend only on the structure of the molecule and the type of the stationary phase, but this approximation is incorrect. This study is devoted to studying the dependence of retention indices on the column heating rate in the linear temperature programming mode, using a large and diverse data set. In the NIST 20 database, most data records are recorded in this mode. For stationary phases based on poly(5%-diphenyl-95%-dimethyl)siloxane (5%-phenyl-PDMS), there is a high proportion of records with heating rates of 10-15 K/min. In practice, such a high heating rate is rarely used and the use of such data may cause errors. A search was made for groups of records that were taken from the same primary source, recorded for the same compound and the same stationary phase, but differing in a heating rate. For each of these groups, the value D, the angular coefficient (slope) of the dependence of the retention index on the heating rate, was calculated. This value can take both positive and negative values. The highest values and the greatest variation of D values are observed for polar stationary phases, but further consideration was performed for 5%-phenyl-PDMS due to its greater practical significance. For these stationary phases, the highest D values are observed for aromatic and polyaromatic molecules; oxygen-containing compounds, on the contrary, exhibit lower D values. Negative D values are observed for many trimethylsilyl derivatives. A data set of D values for 756 molecules was selected and published online. There is almost no correlation between D and the retention index, lipophilicity factor logP, and molecular weight. Significant correlations with the number of cycles, the number of rotatable bonds, and the number of aromatic atoms were observed. Linear equations quantitatively relating the molecular descriptors to the D value were constructed. A number of cycles and halogen atoms were shown to contribute positively to the D value, while a number of oxygen atoms and bonds subject to internal rotation contributed negatively. The strong influence of the values related to the conformational rigidity of molecules and the weak influence of polarity allow us to suppose that the entropic factor has a key influence on the D value. A simple empirical linear equation for estimating the value of D is derived and presented in this study. Several machine learning methods for predicting D are compared. The best results are shown by gradient boosting and a random forest. However, the random forest does not achieve high accuracy in predicting the retention indices themselves.

Predicting the Thermodynamic Characteristics of New Products of N,N-Dimethylhydrazine Transformation in the Gas Phase

Erratum to: Predicting the Thermodynamic Characteristics of New Products of N,N-Dimethylhydrazine Transformation in the Gas Phase

Validation of the identification reliability of known and assumed UDMH transformation products using gas chromatographic retention indices and machine learning

Study on Conformation Interconversion of 3-Alkyl-4-acetyl-3;4-dihydro-2h-1;4-benzoxazines from Dynamic NMR Experiments and Ab Initio Density Functional Calculations

Thermodynamic analysis and calculation of 3,4-dimethyl-1H-yl-pyrazole preparation

Identification Complexity of the Products of Free-Radical Chlorination of Indane by Gas Chromatography–Mass Spectrometry

Inverse Gas Chromatographic Study of Sorption Thermodynamics in Thermally Rearranged Polymer Based on 2,2-Bis(3-amino-4-hydroxyphenyl)-hexafluoropropane and 4,4′-Hexafluoroisopropylidene Diphthalic Anhydride

Calculation of Thermochemical and Detonation Parameters of Azido-Acetylenic Derivatives of s-Triazine

Study of Vapor–hydrate Two-Phase Equilibria

Ready‐to‐use Models Built Using a Diverse Set of 266 Aroma Compounds for the Estimation of Gas Chromatographic Retention Indices for the 50%‐Cyanopropylphenyl‐50%‐Dimethylpolysiloxane Stationary Phase

Intelligent Workflow and Software for Non-Target Analysis of Complex Samples Using a Mixture of Toxic Transformation Products of Unsymmetrical Dimethylhydrazine as an Example

Thermochemistry, Tautomerism, and Thermal Decomposition of 1,5-Diaminotetrazole: A High-Level ab Initio Study

Ab Initio Kinetics for Thermal Decomposition of CH3N•NH2, Cis-Ch3nhn•h, Trans-Ch3nhn•h, and C•H2NNH2 Radicals.

Large-scale statistical study of the dependence of retention index on heating rate in temperature-programmed gas chromatography

Hydrate-based energy storage: Studying mixed CH 4 /1,3-dioxane hydrates via thermodynamic modeling, in-situ Raman spectroscopy, and macroscopic kinetics

Retention Behaviors and Thermodynamic Properties of Phenol and Di- hydroxybenzene Isomers on the Reversed-phase Liquid Chromatography

Why Should We Use Residual Thermodynamics for Calculation of Hydrate Phase Transitions?

Efficient Reaction‐Based Approaches for Gas‐Phase Enthalpy of Formation Prediction and their Application to Large (C32) Polycyclic Aromatic Hydrocarbons

Effect of Thermodynamic Parameters on Prediction of Phase Behavior and Process Design of Extractive Distillation

Thermodynamic Analysis of Chemical Hydrogen Storage: Energetics of Liquid Organic Hydrogen Carrier Systems Based on Methyl-Substituted Indoles

Thermochemical Properties of Trinitromethyl-1,3,5-Triazines