Abstract:The increase in the thermal protection level of the existing buildings enclosing structures, due to the need to comply with the current norms of building heat engineering requirements, leads to increasing in the part of heat losses in the thermal balance of a building due to infiltration and exhaust ventilation operation. After exhaustion of the possibilities for the implementation of technical measures to reduce energy costs by changing in volumetric planning solutions and insulating building envelopes further decreasing heat consumption level should be associated with the use of the secondary and renewable resources potential. The paper presents the results of assessing the technical and economic feasibility of using the exhaust air thermal potential for heating the supply air in the forced supply-and-exhaust ventilation system of a building taking as a low-capacity unit as an example. For a counterflow air-to-air recuperative type heat utilizer finned with ribbed heat pipes in the form of a plurality of continuous sheets, the influence of changes in the physical properties of the exhaust air during the phase transition of the water vapor contained in it into a liquid state on the heat exchanger-utilizer performance and characteristics of its efficiency has been established. The conditions of heat exchange are determined (without condensate, with condensate in the part of the heat exchanger-utilizer, with condensate in the entire heat exchanger-utilizer and with the risk of icing) in the supply air temperature range from (–26) to (+8) °C for three variants of its operation with a balance of the nominal amount of exhaust and supply air and with two variants of imbalance. Variants with imbalances have been investigated in order to find possible combinations of supply and exhaust air temperatures, at which there would be no phase transition of water vapor in the exhaust air flow to the liquid state in the entire volume of the heat utilizer, which would eliminate the need for measures to collect and remove condensate and preventing it from freezing.

Exergy efficiency and heat transfer from the condenser in heat pump systems

Performance Analysis and Evaluation of a Supercritical CO2 Rankine Cycle Coupled with an Absorption Refrigeration Cycle

Energy and Exergy Efficiency Analysis of Solar Driven Ejector–compressor Heat Pump Cycle

A thermodynamic analysis of a transcritical cycle with refrigerant mixture R32/R290 for a small heat pump water heater

Experimental investigation of exergy, exergoenvironmental and exergoenviroeconomic analysis of the heat pump system

A comprehensive exergy-based evaluation on cascade absorption-compression refrigeration system for low temperature applications - exergy, exergoeconomic, and exergoenvironmental assessments

Analysis of the influence of condensation temperature and compressor efficiency on heat pump system efficiency

An experimental investigation of secondary fluid parameters on heat pumps with higher temperature lift and zeotropic working fluid

A competitive study of a geothermal heat pump equiped with an intermediate economizer for R134a and R513A working fluids

Examination of the performance effects of refrigerants in a multistage refrigeration cycle using advanced exergy analysis

Experimental exergy destruction analysis of an air to air heat pump operating in cooling mode

High-efficiency Cooling Solution for Exhaust Air Heat Pump: Modeling and Experimental Validation

Exergy analysis and experiments on high temperature dehumidifying heat pump

Energy And Exergy Analysis Of A Two-Stage Cascade Vapor Compression Refrigeration System With Modified System Configuration

Theoretical and experimental investigation of a heat pipe heat exchanger for energy recovery of exhaust air

Recuperative Heat Exchanger-Utilizer Thermodynamic Modes in Low Capacity Supply-and-Exhaust Ventilation Unit

Dual-pressure condensation high temperature heat pump system for waste heat recovery: Energetic and exergetic assessment

Thermodynamic properties of non-azeotropic refrigerant heat pumps under full operating conditions with non-phase-change heat sinks and heat soucres

Experimental study of the structure of vapor phase during boiling of R134a on heat exchange surfaces of heat pump

Design Criteria of Different Heat Exchangers for the Optimal Thermodynamic Performance of Regenerative Refrigeration Systems

Energy efficiency of a reversible refrigeration unit using R410A or R32