Abstract:OBJECTIVE:To investigate the changes of the vertical height and width of the alveolar bone six months after the alveolar ridge preservation in periodontal compromised molar sites of severe alveolar bone defects with clinical direct measurement, parallel periapical radiographs, and cone-beam computed tomography (CBCT), and to analyze the effect of the three different methods of measurement. METHODS:In this study, 20 subjects requiring tooth extraction on account of periodontal disease with a total of 23 extracted molars were enrolled. Extractions were performed atraumatically and patients were received alveolar ridge preservation procedure with Bio-Oss and Bio-Gide. Clinical direct measurements were taken after tooth extraction and during the implant surgery 6 months later, CBCT scans and parallel periapical radiographs were taken immediately after ridge preservation and 6 months later. The changes of alveolar ridge width and vertical height after six months were measured and analyzed through the above-mentioned three methods and the similarities and differences of the measured effect were compared. RESULTS:There were no significant difference of alveolar vertical height in the center of the extraction sites, the center of distal aspect, and distobuccal aspect between the clinical direct measurements and the CBCT measurements (P>0.05), alveolar vertical height in other points and alveolar width measurements were statically significant (P<0.05). After 6 months, 10 sites of 10 subjects were received a flap and re-entered to perform dental implants surgery. The vertical height in the center of alveolar increased significantly and the changes of alveolar vertical height of clinical direct and CBCT measurement were (6.15 ± 1.73) mm and (6.59 ± 2.53) mm, respectively. The measurements of the width of the alveolar bone were (8.45 ± 1.18) mm and (8.52 ± 1.27) mm, respectively. The measurements of the two methods were not statistically significant (P>0.05). The change of the alveolar height in the center of the extraction socket after six months measured by parallel periapical was (5.84 ± 4.28) mm, which was closed to the clinical direct measurement and the CBCT measurement. CONCLUSION:Clinical direct measurement and CBCT measurement were largely consistent in the evaluation of the alveolar bone height and width after the alveolar ridge preservation using deproteinized boving bone mineral (DBBM, Bio-Oss) and bioabsorbable collagen membrane (Bio-Gide) in periodontal compromised molar sites of severe bone defects.

Comparative Analysis of Two Different Techniques for Ridge Preservation Following Tooth Extraction: A Clinical and Radiographic Study

Preservation of Alveolar Ridge using Graft Material after Tooth Extraction: A Clinical Trial

[Radiographic Evaluation of Ridge Preservation after Molar Tooth Extraction: a Controlled Clinical Trial].

Histological Evaluation of Alveolar Ridge Preservation Using Different Bone Grafts: Clinical Study Analysis Part II

Comparison of the Efficacy of Platelet-Rich Fibrin and Bone Allograft for Alveolar Ridge Preservation after Tooth Extraction: A Clinical Trial

Combined use of xenogeneic bone substitute material covered with a native bilayer collagen membrane for alveolar ridge preservation: A randomized controlled clinical trial.

An open randomized controlled clinical trial to evaluate ridge preservation and repair using SocketKAP(™) and SocketKAGE(™) : part 2 - three-dimensional alveolar bone volumetric analysis of CBCT imaging

Comparative Study between a Novel In Vivo Method and CBCT for Assessment of Ridge Alterations after Socket Preservation-Pilot Study

Comparison of the effects of two extraction methods on the alveolar ridge preservation of Maxillary Anterior Teeth

Comparative Effectiveness of an Autologous Dentin Matrix for Alveolar Ridge Preservation

Soft tissue contour and radiographic evaluation of ridge preservation in early implant placement: A randomized controlled clinical trial

[Two Procedures for Ridge Preservation of Molar Extraction Sites Affected by Severe Bone Defect Due to Advanced Periodontitis].

Alveolar ridge dimensional changes following ridge preservation procedure using SocketKAP(™) : exploratory study of serial cone-beam computed tomography and histologic analysis in canine model

Competence of allogenic demineralized tooth matrix in socket seal surgery for alveolar ridge preservation: a randomized control clinical trial

Efficacy of Autogenous Dentin Biomaterial on Alveolar Ridge Preservation: A Randomized Controlled Clinical Trial

Long-term preservation of ridge dimension following tooth extraction and ridge preservation: A randomized controlled trial of healing at 4- and 12-month healing time points

[Evaluation with Different Measuring Methods for the Alveolar Bone Change of Ridge Preservation in Molar Sites].

A Novel Technique to Preserve the Alveolar Ridge Width Following Tooth Extraction in the Maxillary Frontal Area

Preservation and Augmentation of Molar Extraction Sites Affected by Severe Bone Defect Due to Advanced Periodontitis: A Prospective Clinical Trial

Clinical evaluation of different alveolar ridge preservation techniques after tooth extraction: a randomized clinical trial

The efficiency of two different synthetic bone graft materials on alveolar ridge preservation after tooth extraction: a split-mouth study