Abstract:The recent discovery of high temperature superconductivity in a layered iron arsenide has led to an intensive search to optimize the superconducting properties of iron-based superconductors by changing the chemical composition of the spacer layer that is inserted between adjacent anionic iron arsenide layers. Until now, superconductivity has only been found in compounds with a cationic spacer layer consisting of metal ions: Li+, Na+, K+, Ba2+ or a PbO-type or perovskite-type oxide layer. Electronic doping is usually necessary to control the fine balance between antiferromagnetism and superconductivity. Superconductivity has also been reported in FeSe, which contains neutral layers similar in structure to those found in the iron arsenides but without the spacer layer. Here we demonstrate the synthesis of Lix(NH2)y(NH3)1-yFe2Se2 (x ~0.6 ; y ~ 0.2), with lithium ions, lithium amide and ammonia acting as the spacer layer, which exhibits superconductivity at 43(1) K, higher than in any FeSe-derived compound reported so far and four times higher at ambient pressure than the transition temperature, Tc, of the parent Fe1.01Se. We have determined the crystal structure using neutron powder diffraction and used magnetometry and muon-spin rotation data to determine the superconducting properties. This new synthetic route opens up the possibility of further exploitation of related molecular intercalations in this and other systems in order to greatly optimize the superconducting properties in this family.

Enhanced superconducting properties in FeCr$_x$Se

Superconductivity in Fe(Se,Te) Polycrystalline Bulk with Fe Partially Substituted by Cr

Phase Diagram and Annealing Effect for Fe1+δTe1−xSxsingle Crystals

Impact of Fe site Co substitution on superconductivity of Fe1-xCoxSe0.5Te0.5 (x = 0.0 to 0.10): A flux free single crystal study

Highly-Tunable Crystal Structure and Physical Properties in FeSe-Based Superconductors

Density Functional Study of the Over-Doped Iron Chalcogenide: TlFe$_{2}$Se$_{2}$ with ThCr$_{2}$Si$_{2}$ structure

Effect of Fe excess on structural, magnetic and superconducting properties of single-crystalline Fe(1+x)Te(1-y)Se(y)

Improvement of Superconducting Properties of Fe1-xCrxSeyTe1-y Polycrystalline Bulks

Interstitial Iron Controlled Superconductivity in Fe1+xTe0.7Se0.3

Inconsistent pressure effect on superconducting transition temperature and volume in Fe<sub>1+<i>y</i></sub>Te<sub>1−<i>x</i></sub>Se<sub><i>x</i></sub>single crystals

Different response of superconductivity to the transition-metal impurities in K0.8Fe2−y−xMxSe2 (M = Cr, Mn, Co, Zn)

Magnetic and Superconducting Properties of Single Crystals of Fe$_{1+\delta}$Te$_{1-x}$Se$_x$ System

Enhancement of superconducting transition temperature of FeSe by intercalation of a molecular spacer layer

Enhanced superconductivity in FeSe/SrTiO$_3$ from the combination of forward scattering phonons and spin fluctuations

Different Response Of Superconductivity To The Transition-Metal Impurities In K(0.8)2yxm(X)Se(2) (M = Cr, Mn, Co, Zn)

Superconductivity And Magnetic Properties Of Single Crystals Of K0.75fe1.66se2 And Cs0.81fe1.61se2

Coexistence of superconductivity and antiferromagnetism in single crystals $A_{0.8}Fe_{2-y}Se_2$ (A= K, Rb, Cs, Tl/K and Tl/Rb): evidence from magnetization and resistivity

Cometal addition effect on superconducting properties and granular behaviours of polycrystalline FeSe0.5Te0.5

Synthesis, crystal and magnetic structure of iron selenide BaFe2Se3 with possible superconductivity at Tc=11K

Fast suppression of superconductivity with Fe site Ni substitution in Fe1-xNixSe0.5Te0.5 (x=0.0, 0.01, 0.03, 0.05, 0.07, 0.10 and 0.20) single crystals

Superconductivity and Magnetic Properties of high-quality single crystals of $A_{x}$Fe$_2$Se$_2$ ($A$ = K and Cs)