Abstract:Wireless networks are built upon a shared medium that makes it easy for adversaries to launch jamming-style attacks. These attacks can be easily accomplished by an adversary emitting radio frequency signals that do not follow an underlying MAC protocol. Jamming attacks can severely interfere with the normal operation of wireless networks and, consequently, mechanisms are needed that can cope with jamming attacks. In this paper, we examine radio interference attacks from both sides of the issue: first, we study the problem of conducting radio interference attacks on wireless networks, and second we examine the critical issue of diagnosing the presence of jamming attacks. Specifically, we propose four different jamming attack models that can be used by an adversary to disable the operation of a wireless network, and evaluate their effectiveness in terms of how each method affects the ability of a wireless node to send and receive packets. We then discuss different measurements that serve as the basis for detecting a jamming attack, and explore scenarios where each measurement by itself is not enough to reliably classify the presence of a jamming attack. In particular, we observe that signal strength and carrier sensing time are unable to conclusively detect the presence of a jammer. Further, we observe that although by using packet delivery ratio we may differentiate between congested and jammed scenarios, we are nonetheless unable to conclude whether poor link utility is due to jamming or the mobility of nodes. The fact that no single measurement is sufficient for reliably classifying the presence of a jammer is an important observation, and necessitates the development of enhanced detection schemes that can remove ambiguity when detecting a jammer. To address this need, we propose two enhanced detection protocols that employ consistency checking. The first scheme employs signal strength measurements as a reactive consistency check for poor packet delivery ratios, while the second scheme employs location information to serve as the consistency check. Throughout our discussions, we examine the feasibility and effectiveness of jamming attacks and detection schemes using the MICA2 Mote platform.

AntiJam: Efficient Medium Access despite Adaptive and Reactive Jamming

The Feasibility of Launching and Detecting Jamming Attacks in Wireless Networks.

Anti-jamming Timing Channels for Wireless Networks

Defending Wireless Networks from Radio Interference Attacks

Reactive Jamming and Attack Mitigation over Cross-Technology Communication Links

Jamming Sensor Networks: Attack and Defense Strategies

On Adjusting Power to Defend Wireless Networks from Jamming

Jamming Mobility in 802.11p Networks: Modeling, Evaluation, and Detection

Jamming Modulation: An Active Anti-Jamming Scheme

Efficient Anti-Jamming Strategies in Multi-Channel Wireless Networks

Joint Adaptation of Frequency Hopping and Transmission Rate for Anti-Jamming Wireless Systems

Principles of Robust Medium Access and an Application to Leader Election

Cost-Efficient Wireless Friendly Jamming and Interference Mitigation: No Pains, No Gains

SecureMAC: Securing Wireless Medium Access Control Against Insider Denial-of-Service Attacks

Accumulate and Jam: Towards Secure Communication via A Wireless-Powered Full-Duplex Jammer

A Novel Anti-Jamming Method in Wireless Sensor Networks: Using Artificial Noise to Actively Interfere the Intelligent Jammer

Countermeasure for Smart Jamming Threat: A Deceptively Adversarial Attack Approach.

Jam Sessions: Analysis and Experimental Evaluation of Advanced Jamming Attacks in MIMO Networks

Anti-jamming attack communication by adaptive rateless codes in wireless networks

Anti-Reactive Jamming Technology Based on Jamming Utilization

Resilient-By-Design Framework for MIMO-OFDM Communications under Smart Jamming