Study on Coal Moisture Control Technology Using Superheated Steam
Zhong-Hua Wu,Bing Liu,Jian-Shu Yin,Ning Kang,Li-Juan Zhao
DOI: https://doi.org/10.2991/icsd-17.2017.29
2017-01-01
Abstract:To avoid the fire and explosion danger in the current coking coal moisture control technology, a new coal moisture control technology was proposed in this paper where the superheated steam was used as the drying medium. A self-developed lab scale superheated steam drying experimental setup was constructed and the coal moisture control experiments were carried out. Experimental results showed that the superheated steam can be used as drying medium to reduce the coal moisture from initial 11.9% into the required 6% successfully. Super heated steam temperature,the thickness of coking coal are the key governing parameter in the drying process. Under this experimental condition,when super heated steam temperature increased from 130°C to 190°C,the drying time of coking coal was shortened from 6min to only 1.5 min. The superheated steam was promising for developing a fast, energy saving coking coal moisture control technology. Introduction The coking coal used in the coking plants of China is usually washed coal, and its moisture content was usually 9%-12%. The coking coal with a high moisture content will carry a mount of water into the coke oven. This water will evaporate into vapor during the coking process in the coke oven and finally form into harmful waste water,which needs to be treated. Furthermore, the evaporation of moisture during the coking process will consume some energy which used for coal coking, resulting a increasing amount and cost of coking gas. These problems require the coking plants to reduce the moisture content of the coking coal before coking and such technology is called as “coal moisture control” . The coal moisture control is the abbreviation of "water control process for loading coal",which mostly use the waste heat from the coking plant, such as high-temperature flue gas to heated the coal to remove its part of the moisture, so as to keep the moisture content of the coal at about 6% before the furnace is installed[1-3]. The current coal moisture control technology generally use the flue gas as the drying medium. Since the flue gas comprise the oxygen and the dried coal particle easily form dust. Thus the fire and explosion danger exist when using the flue gas. To avoid this problem, a new coal moisture control technology was proposed where the inert superheated steam was used as the drying medium to dry the coking coal into the required moisture content. The superheated steam was already used for drying of timber, foodstuffs, biomass, etc and its merits reported includes remarkable energy saving effect, good drying quality, high heat and mass transfer efficiency, no fire and explosion hazard[4-10]. In this paper, the superheated steam moisture control technology was developed for the coking coal where super heated steam was used as a heat medium to control moisture of coking coal into about 6%. A series of drying experiments were conduced to study the temperature and pressure of super heated steam, its velocity, the thickness of coking coal,etc on the drying process of the moist coking coal. The experimental results increase the knowledge of the super heated steam coking coal moisture control technology. 189 This is an open access article under the CC BY-NC license (http://creativecommons.org/licenses/by-nc/4.0/). Copyright © 2017, the Authors. Published by Atlantis Press. Advances in Engineering Research (AER), volume 111 3rd Annual 2017 International Conference on Sustainable Development (ICSD2017)