Lactate determination in exercise testing using an electrochemical analyser: with or without blood lysis?

A G Thin,Z Hamzah,M X FitzGerald,P McLoughlin,R Freaney
DOI: https://doi.org/10.1007/s004210050489
Abstract:The practical use of lactate electrochemical analysers in exercise testing has not been adequately examined. Initial studies have reported differences in lactate concentration between that measured spectrophotometrically and that measured electrochemically. The study described here was undertaken to compare, using the statistical technique of Bland and Altman (1986), two widely available methods of measuring lactate using lysed and non-lysed blood samples and the lactate thresholds derived from the measured lactate values using a log-log transform technique. Thirteen normal, healthy young adults (11 male) undertook progressive exercise tests to exhaustion. Arterialised venous blood samples were taken each minute and the lactate concentration therein was measured both spectrophotometrically and electrochemically and either with or without lysis of the blood samples. The lactate concentrations measured in lysed blood using both methods (182 pairs) were in close agreement. The electrochemical values obtained using non-lysed blood were systematically lower than spectrophotometric values (206 pairs), the difference becoming progressively greater at higher lactate concentrations. Results for the lactate threshold comparisons are given as mean difference (limits of agreement with 95% probability). Lactate thresholds (12 pairs) derived from lysed blood lactate concentrations measured spectrophotometrically and electrochemically were not significantly different -30 (240) ml O2 x min(-1). Lactate thresholds (11 pairs) derived from lysed spectrophotometric and non-lysed electrochemical measurements were also not significantly different + 20 (250) ml O2 x min(-1). Thus, despite the difference in the measured lactate concentrations, the derived lactate thresholds are in agreement and, therefore, electrochemical analysers can be used for lactate threshold determination using the log-log transform technique without sample lysis.
What problem does this paper attempt to address?