Abstract:The characteristics of radial pressure distribution inside side chamber and leakage flow through balancing holes of centrifugal pumps are very important for accurately predicting the axial thrust produced by a balancing system. Therefore, a rapid and sufficiently accurate calculation method is required. An integrated model describing the characteristics of radial pressure distribution inside side chamber and leakage flow rate through balancing holes was established. In this model, the correction coefficient of liquid pressure at side chamber entrance and the discharge coefficient of balancing holes were obtained by experiment. The IS 80-50-315 type single-suction, single-stage, and cantilevered centrifugal pump with the structure of double wear-rings and balancing holes was employed as a model to investigate the characteristics of internal liquid flow of the balancing system. Under different pump flow rates, pump performance curves, radial pressure distribution inside side chamber, and leakage flow rate through balancing holes were examined with different balancing hole diameters. Afterward, the experimental data were compared with the predicted results. The comparisons showed a reasonable consistency. Consequently, according to detailed pump dimensions and operating conditions, the integrated model in current form is recommended for centrifugal pumps, which have low specific speed and are with balancing systems of double wear-rings and balancing holes. This can be used for the prediction of radial pressure distribution inside side chamber and leakage flow rate through balancing holes and can be used both at the design stage and nondesign stage.

Modeling and evaluation of centrifugal pump performance degradation model based on stochastic process

Effect of Relative Positions between Blade and Volute Tongue on Prediction of Performance in Simulation of Centrifugal Pump

Discrete Reliability Analysis Method for Multistage Centrifugal Pump Transmission Structure Based on Sparse Grid Model

Degradation Assessment and Remaining Useful Life Prognostic of Centrifugal Pump Using Multi-Sensor Process Monitoring

Safety integrity level evaluation of nuclear centrifugal pump based on performance degradation data

A Novel Degradation Modeling and Prognostic Framework for Closed-Loop Systems with Degrading Actuator

Probabilistic Modeling and Prediction of Dynamic Discharge Process in Multiphase Pumps

Modeling and Analysis of the Churning Losses Characteristics of Swash Plate Axial Piston Pump

Optimization of a Centrifugal Pump to Improve Hydraulic Efficiency and Reduce Hydro-Induced Vibration

Multistage hybrid model for performance prediction of centrifugal pump

Main Fuel Pump Health Monitoring Method Based on Kriging Surrogate Model

Engineering‐driven performance degradation analysis of hydraulic piston pump based on the inverse Gaussian process

Investigation of the integrated model of side chamber, wear-rings clearance and balancing holes for centrifugal pumps

Degradation Modeling Considering the Dependency of Rate and Volatility for Real-Time Prognostics with Error Correction

Performance Reliability Analysis of a Piston Pump Affected by Random Degradation

Two-Stage Hybrid Model for Efficiency Prediction of Centrifugal Pump

The Remaining Useful Life Prediction Method of a Hydraulic Pump under Unknown Degradation Model with Limited Data

A Data-Driven Segmented Model Based on Variance Information for Centrifugal Pump Efficiency Prediction

Remaining Useful Life Prediction Based on the Wiener Process for an Aviation Axial Piston Pump

Prediction of Centrifugal Pump Performance Parameters Based on a Multilayer Hybrid Model

Performance Degradation Model of Roots Pump in Vacuum System Based on Leakage of Rotor Wear