Abstract:We performed decompression experiments to simulate the ascent of a phenocryst-bearing rhyolitic magma in a volcanic conduit. The starting materials were bubble-free rhyolites water-saturated at 200 MPa–800°C under oxidizing conditions: they contained 6.0 wt% dissolved H2O and a dense population of hematite crystals (8.7 ± 2 × 105 mm−3). Pressure was decreased from the saturation value to a final value ranging from 99 to 20 MPa, at constant temperature (800°C); the rate of decompression was either 1,000 or 27.8 kPa/s. In all experiments, we observed a single event of heterogeneous bubble nucleation beginning at a pressure PN equal to 63 ± 3 MPa in the 1,000 kPa/s series, and to 69 ± 1 MPa in the 27.8 kPa/s series. Below PN, the degree of water supersaturation in the liquid rapidly decreased to a few 0.1 wt%, the nucleation rate dropped, and the bubble number density (BND) stabilized to a value strongly sensitive to decompression rate: 80 mm−3 at 27.8 kPa/s vs. 5,900 mm−3 at 1,000 kPa/s. This behaviour is like the behavior formerly described in the case of homogeneous bubble nucleation in the rhyolite-H2O system and in numerical simulations of vesiculation in ascending magmas. Similar degrees of water supersaturation were measured at 27.8 and 1,000 kPa/s, implying that a faster decompression rate does not result in a larger departure from equilibrium. Our experimental results imply that BNDs in acid to intermediate magmas ascending in volcanic conduits will depend on both the decompression rate \documentclass[12pt]{minimal}\usepackage{amsmath}\usepackage{wasysym}\usepackage{amsfonts}\usepackage{amssymb}\usepackage{amsbsy}\usepackage{mathrsfs}\usepackage{upgreek}\setlength{\oddsidemargin}{-69pt}\begin{document}$$ \left| {\left. {{\text{d}}P/{\text{d}}t} \right|} \right. $$\end{document} and the number density of phenocrysts, especially the number density of magnetite microphenocrysts (1–100 mm−3), which is the only mineral species able to reduce significantly the degree of water supersaturation required for bubble nucleation. Very low BNDs (≈1 mm−3) are predicted in the case of effusive eruptions (\documentclass[12pt]{minimal}\usepackage{amsmath}\usepackage{wasysym}\usepackage{amsfonts}\usepackage{amssymb}\usepackage{amsbsy}\usepackage{mathrsfs}\usepackage{upgreek}\setlength{\oddsidemargin}{-69pt}\begin{document}$$ \left| {\left. {{\text{d}}P/{\text{d}}t} \right|} \right. $$\end{document} ≈ 0.1 kPa/s). High BNDs (up to 107 mm−3) and bimodal bubble size distributions are expected in the case of explosive eruptions: (1) a relatively small number density of bubbles (1–100 mm−3) will first nucleate in the lower part of the conduit (\documentclass[12pt]{minimal}\usepackage{amsmath}\usepackage{wasysym}\usepackage{amsfonts}\usepackage{amssymb}\usepackage{amsbsy}\usepackage{mathrsfs}\usepackage{upgreek}\setlength{\oddsidemargin}{-69pt}\begin{document}$$ \left| {\left. {{\text{d}}P/{\text{d}}t} \right|} \right. $$\end{document} ≈ 10 kPa/s), either at high pressure on magnetite or at lower pressure on quartz and feldspar (or by homogeneous nucleation in the liquid) and (2) then, extreme decompression rates near the fragmentation level (\documentclass[12pt]{minimal}\usepackage{amsmath}\usepackage{wasysym}\usepackage{amsfonts}\usepackage{amssymb}\usepackage{amsbsy}\usepackage{mathrsfs}\usepackage{upgreek}\setlength{\oddsidemargin}{-69pt}\begin{document}$$ \left| {\left. {{\text{d}}P/{\text{d}}t} \right|} \right. $$\end{document} ≈ 103 kPa/s) will trigger a major nucleation event leading to the multitude of small bubbles, typically a few micrometers to a few tens of micrometers in diameter, which characterizes most silicic pumices.

The influence of Fe Ti oxide microlites on bubble nucleation in rhyolitic melts

Evaluating the Role of Titanomagnetite in Bubble Nucleation: Novel Applications of Low Temperature Magnetic Analysis and Textural Characterization of Rhyolite Pumice and Obsidian From Glass Mountain, California

Kinetics of heterogeneous bubble nucleation in rhyolitic melts: implications for the number density of bubbles in volcanic conduits and for pumice textures

Evaluating the Role of Titanomagnetite in Bubble Nucleation: Rock Magnetic Detection and Characterization of Nanolites and Ultra‐Nanolites in Rhyolite Pumice and Obsidian From Glass Mountain, California

Oxide nanolitisation-induced melt iron extraction causes viscosity jumps and enhanced explosivity in silicic magma

Vapor-bubble growth in olivine-hosted melt inclusions

Study on Bubble Nucleation in Liquid Metal

Time-series experiments of pyroxene crystal nucleation and growth in basaltic magmas and implications for magma rheology

Melting of Fe-bearing and Fe-free carbonated pelites under fluid-saturated conditions at 6 GPa

The rheological response of magma to nanolitisation

Effects of H2O-CO2 Fluids, Temperature, and Peridotite Fertility on Partial Melting in Mantle Wedges and Generation of Primary Arc Basalts

Revisiting Magnesium Isotope Constraints on the Petrogenesis of the Fe-Ti Oxide-Bearing Mafic–ultramafic Intrusions

The Effects of Small Amounts of H2O, CO2 and Na2O on the Partial Melting of Spinel Lherzolite in the System CaO–MgO–Al2O3–SiO2 ± H2O ± CO2 ± Na2O at 1·1 GPa

Vesicularity, bubble formation and noble gas fractionation during MORB degassing

ON THE PARTIAL MELTING OF SPINEL LHERZOLITE IN THE SYSTEM CaO – MgO – Al

EFFECTS OF P 2 O 5 AND TiO 2 ON THE PARTIAL MELTING OF SPINEL LHERZOLITE IN THE SYSTEM CaO – MgO – Al

CO2 bubble generation and migration during magma–carbonate interaction

Experimental Evidence of Primary Permeability at Very Low Gas Content in Crystal‐Rich Silicic Magma

Effects of P2o5 and Tio2 on the Partial Melting of Spinel Lherzolite in the System Cao-Mgo-Al2o3-Sio2 at 1.1 Gpa

Insights on Arc Magmatic Systems Drawn from Natural Melt Inclusions and Crystallization Experiments at PH2O = 800 MPa under Oxidizing Conditions

Immiscible hydrous Fe–Ca–P melt and the origin of iron oxide-apatite ore deposits