Abstract:The contamination of water resources by emerging contaminants, such as heavy metals and textile effluents, poses significant ecological and human health risks. Conventional effluent treatment plants may not effectively degrade all types of pollutants, resulting in the contamination of natural water resources. Photocatalysis, specifically the photo-Fenton reaction, has emerged as an efficient sustainable cost-effective method for the removal of pollutants. In this study, three batches (CF-1, CF-2, and CF-3) of copper ferrite nanoparticles (NPs) were synthesized and used as photocatalysts for the degradation of methylene blue (MB) dye and reduction of hexavalent chromium (Cr(VI)) under visible light. The CF-1, CF-2, and CF-3 required (90, 75, and 60 min.) different periods to reach a nearly similar degradation percentage, i.e., 90%, wherein the CF-3 batch demonstrated better catalytic activity. The successful synthesis of copper ferrite NPs was confirmed by XRD analysis which reveals the CuFe 2 O 4 phase. With the increased concentration of copper, the formation of the CuO phase alongside the CuFe 2 O 4 phase was observed. The CF-3 catalyst had a surface area of 44.496 m 2 /g according to BET studies. The catalyst exhibited a pore radius of 19.175 Å and an adsorption pore volume of 0.109 cc/g, as determined by the BJH method. TEM micrographs showed spherical-shaped NPs with sizes ranging from 55 to 60 nm. The photo-Fenton process was optimized by varying dye concentration, pH, catalyst, and hydrogen peroxide (H 2 O 2 ) dosages for MB degradation. The scavenger study reveals the contribution of the •OH radical over •O 2 − radical in the photo-Fenton process for MB degradation. The reduction of Cr(VI) was optimized by adjusting pH and Cr load. The CF-3 catalyst exhibited almost complete degradation of MB (32 mg/L) within 60 min and reduction of Cr(VI) (100 mg/L) within 20 min. The good reusability of the catalyst exhibits 71.4% MB degradation after four cycles and 78.34% Cr(VI) reduction after five cycles. The regression coefficient ( R 2 ) of the pseudo-second-order reaction was close to 1 and higher than the pseudo-first-order reaction. The catalyst achieved 0.0540 and 0.1047 1/min kinetic constant at pseudo-first-order reaction, while 0.0614 and 0.0497 L/mg.min kinetic constant was achieved at pseudo-second-order reaction for MB degradation and Cr(VI) reduction. These kinetic studies proved that the dye degradation and chromium reduction follow the pseudo-second-order reaction ( R 2 ). The overall study demonstrates the promising potential of magnetic CF-3 nanoparticles as efficient catalysts for industrial applications in dye degradation and Cr(VI) reduction.

Magnetically Reusable Fe3O4‐CuO Nanoparticles as Catalysts for the Synthesis of Aryl‐Substituted Fluorescent Pyrazines for Fe Sensing and Ink Applications

Enhanced Catalytic Reduction and Electrochemical Sensing Properties of Magnetic Fe3O4@benzothiazole-Cu(II) Nanoparticles

Fabrication and characterization of copper complex immobilized on magnetic nanoparticles: an efficient and ecofriendly nanomagnetic catalyst for synthesis of imidazo[1,2-a]pyridines and pyranopyrazoles

ChemInform Abstract: Fe3O4 Nanoparticle‐Supported Copper(I): Magnetically Recoverable and Reusable Catalyst for the Synthesis of Quinazolinones and Bicyclic Pyrimidinones.

The Study of a Novel High Selectivity Pyrenyl-Based Fluorescence Probe with Aggregation-Induced Emission Characteristics for Fe3+ Detection Designed by a Structure Modulation Strategy

Construction and Characterization of Magnetic Fe3O4 Nanoparticles Supported Palladium Complex: Research on Synthesis of Aryl Nitriles and Tetrazoles

In situ decorated pd NPs on Triazin-encapsulated Fe3O4/SiO2-NH2 as magnetic catalyst for the synthesis of diaryl ethers and oxidation of sulfides

A mini-review on pyrazolines as fluorescent chemosensors for Fe3+

Synthesis of magnetic nanoparticles Fe3O4@CQD@Si(OEt)(CH2)3@melamine@TC@Ni(NO3) with application in the synthesis of 2-amino-3-cyanopyridine and pyrano[2,3-c]pyrazole derivatives

Facile Synthesis of Highly Sensitive Hybrid Nanomaterial Modified with a Fluorescent Probe for Detection of Fe3+ Ions

High oxidase-mimic activity of Fe nanoparticles embedded in an N-rich porous carbon and their application for sensing of dopamine

Mesoporous halloysite nanotubes modified by CuFe2O4 spinel ferrite nanoparticles and study of its application as a novel and efficient heterogeneous catalyst in the synthesis of pyrazolopyridine derivatives

Polymerization-Induced Colloid Assembly Route to Iron Oxide-Based Mesoporous Microspheres for Gas Sensing and Fenton Catalysis.

Synthesis of Fe 3 O 4 /pt Nanoparticles Decorated Carbon Nanotubes and Their Use As Magnetically Recyclable Catalysts

Preparation of Functionalized Superparamagnetic Fe3O4@Dopamine@Metal Ions (Cu+,Ru2+) Nanocomposites and its Catalytic Applications

Preparation and characterization of sulfamic acid-functionalized Fe3O4 nanoparticles as an efficient magnetic nanocatalyst for the facile and eco-friendly synthesis of quinoxalines, benzothiazoles, and benzoxazoles

Catalytic and kinetic studies of CuFe2O4 as a superior heterogeneous nanocatalyst for dye degradation and Cr(VI) reduction

Fe3O4/PANI/CuI as a sustainable heterogeneous nanocatalyst for A3 coupling

Research on synthesis of imidazopyridine-sulfide-aryl derivatives: copper complex immobilized on Fe3O4 nanoparticles catalyzed one-pot C–H bond sulfenylation of imidazopyridines

Novel polycyclic "turn-on" and "turn-off" pyrazoline and pyrazole fluorescent sensors for selective real-world monitoring of Fe3+/Fe2+ in aqueous environments

Preparation of magnetic recoverable nanosize Cu-Fe2O3/Fe photocatalysts