Abstract:Numerous adsorbents have been applied for Heavy Metals (HMs) removal from contaminated water. The aim of this review was to critically analyze the status of research in HMs detection and adsorption, focusing on the adsorption approaches for better defining the corresponding future challenges and their potential solutions. Present research demonstrates the promising outlook for using remote sensing technology in the preliminary selection of contaminated areas before final HMs detection using spectrometry, microwave or electrochemical sensors. Adsorption can then be applied in treating HMs contaminated water due to its high effectiveness and low-cost. Natural zeolites showed 90 %-100 % Pb2+, 2 + , 95 % Cd2+ 2 + and 100 % Cu2+ 2 + removal from water, their effectiveness is affected by initial pH, and adsorbent dosage and size. As synthesized zeolites, zeolitized pumice waste showed 100-500 mg/g of HMs adsorption at pH 4.0-5.0, 57 mg/g Zn2+ 2 + by oxalate-loaded zeolites and 682 mg/g Pb2+ 2 + and 122 mg/g Ni2+ 2 + by zeolite nanoparticle impregnated polysulfone membrane from wastewater. Activated carbon exhibited 99 %-100 % Hg2+, 2 + , 93 % Cu2+ 2 + and 99 % Co2+ 2 + removal from water under acidic environment. Biochar is more ecofriendly and demonstrated its effectiveness in removing up to 98 % Cd2+, 2 + , 97 % Cu2+, 2 + , 99 % Pb and 94 % Zn2+ 2 + from water. Chitosan showed 755 mg/g Pb2+, 2 + , 979 mg/g Cd2+ 2 + and 877 mg/g Cu2+ 2 + removal at pH 2.0-6.0 from wastewater. Peat moss exhibited 96 % Cu2+ 2 + and 50 % Cr6+ 6 + removal from wastewater at lower pH. Similarly, bioremoval showed 143 mg/g Zn2+ 2 + (algae) adsorption at pH 6.0 in, and 90 % Cr6+ 6 + and 98 % Cu2+ 2 + removal by biomass ash. Recently, carbon, magnetic and titanium nanotubes/composites have shown high efficiency and selectivity in HMs removal, but their preparation is often more expensive than their counterparts. In addition, adding enhancement solutions promoted HMs adsorption and reduced treatment time. Chemical precipitation demonstrated feasibility to recycle and recover extracted HMs and spent adsorbent. This review demonstrates the need for highly selective and efficient adsorbent, and guides the future researchers to make funtionalized and organic-inorganic composite HMs adsorbents.

A facile yet versatile method for adsorption and relayed fluorescent detection of heavy metal ions

Highly Selective in Situ Metal Ion Determination by Hybrid Electrochemical “adsorption–desorption” and Colorimetric Methods

A novel bio-based fluorescent N, P-CDs@CMC/PEI composite hydrogel for sensitive detection and efficient capture of toxic heavy metal ions

Highly efficient Pb(II) and Cu(II) removal using hollow Fe3O4@PDA nanoparticles with excellent application capability and reusability

Efficient Removal of Heavy Metals from Melting Effluent Using Multifunctional Hydrogel Adsorbents.

Highly Efficient Adsorptive Removal of Heavy Metal Ion and Cationic Organic Pollutant from Single and Binary Solutions Using an EDTA-modified Agricultural By-Product-based Adsorbent

Heavy Metals Detection and Removal from Contaminated Water: A Critical Review of Adsorption Methods

A Facile Synthesis of Ibandronate Modified Hydroxyapatite Renewable Nanomaterials for Simultaneous Removal of Cu2+/Pb2+ and Chlortetracycline: Experimental Design and Adsorption Mechanism Study

Efficient Removal of Heavy Metal Ions with an EDTA Functionalized Chitosan/Polyacrylamide Double Network Hydrogel

A selective colorimetric and efficient removal strategy for mercury (II) in aquatic system using mesoporous Fe3O4-loaded silver probes

Combined Performance of Hydroxyapatite Adsorption and Magnetic Separation Processes for Cd(II) Removal from Aqueous Solution

Ion-Induced Synthesis of Alginate Fibroid Hydrogel for Heavy Metal Ions Removal

Facile Preparation of Multiphosphonic Acid Functionalised Multi-Walled Carbon Nanotubes for Enhanced Adsorption Properties for Heavy Metal Ions from Wastewaters

Advance in Research of Heavy Metals Removal by Hydroxyapatite and its Composite

Ph-Regulated Fluorescence Sensor Array Detection of Multiple Heavy Metal Ions under Stepwise Prediction

Hybrid Silicate-Hydrochar Composite for Highly Efficient Removal of Heavy Metal and Antibiotics: Coadsorption and Mechanism

Three kinds of apatite adsorbents prepared by co-precipitation for Pb (II) and Cd (II) removal from wastewater: performance, competitive effects and mechanisms

Mechanistic insight into selective adsorption and easy regeneration of carboxyl-functionalized MOFs towards heavy metals

Excellent Capture of Pb(II) and Cu(II) by Hierarchical Nanoadsorbent Fe3O4@SiO2@PAA-SO3H: A Combined Experimental and Theoretical Study.

Biocompatible HA@Fe3 O4 @N-Cds Hybrids for Detecting and Absorbing Lead Ion.

Removal of heavy metal ions from wastewater by a novel HEA/AMPS copolymer hydrogel: preparation, characterization, and mechanism