Stereolithographic additive manufacturing of Luneburg lens using Al2O3-based low sintering temperature ceramics for 5G MIMO antenna
Fei Wang,Zijian Li,Yihui Lou,Fangfang Zeng,Mengmeng Hao,Wen Lei,Xiaochuan Wang,Xiaohong Wang,Guifen Fan,Wenzhong Lu
DOI: https://doi.org/10.1016/j.addma.2021.102244
IF: 11
2021-11-01
Additive Manufacturing
Abstract:In this paper, we provided a manufacturing method for low-sintering-temperature radio frequency (RF) devices by stereolithographic (SLA) printing. The effect of ceramic powder percentage on rheological properties, curing behavior, sintering properties, microstructure, and dielectric properties was discussed. With the proportion of ceramic powder ranging from 60 wt% to 75 wt%, the viscosity of slurries declined, the sintering shrinkage rate varied from 21.61% to 15.83%, the dielectric constant raised from 5.22 to 6.64, and the dielectric loss initially reached the optimum value of 0.0024 and then deteriorated to 0.0035. The maximum solid content of slurries was 75 wt%, and the printable viscosity should be below 7.33 Pa·s. At the mass ratio of 65:35, the samples sintered at 850 °C showed good properties: a density of 3.0135 g·cm−3, a dielectric constant of 5.56, a low dielectric loss of 2.4 × 10−3, and τf = −32.76 ppm/°C. The printed Luneburg lens showed a gain enhancement of over 5 dB, by using a 10 dBi standard gain horn antenna as a feed source. Thus, this research established a foundation for the fabrication of ceramic RF devices with high-performance, complex structures, and low sintering temperature via SLA printing.
engineering, manufacturing,materials science, multidisciplinary