Abstract:Several sinter plants in China are still using significant proportions of local magnetite concentrate in the sinter blend based on supply proximity. However the overall trend is that concentrates are being replaced by more cost effective sinter fines. The fine size of concentrates results in additional challenges for sintering. In this study, granulation and packing experiments were conducted to investigate the influence of concentrate addition level on granule structure and green bed properties under a wide range of moisture and hydrated lime dosage levels. Provided sufficient water is added during granulation, the existence of micro-particles including concentrate and hydrated lime favours granule growth and increases the mass ratio of adhering layer to nuclei. However, at the same moisture and hydrated lime content, the introduction of more concentrate decreases the bed voidage remarkably since the thicker and weaker adhering layer deforms during dynamic packing. Compared to the 100% sinter fines base blend, introducing concentrate has a negative effect on bed permeability and therefore sinter productivity. For the 10% and 30% concentrate blends tested, increasing hydrated lime from 0 wt% to 4 wt% could improve the green bed permeability in JPU from 53.0 to 65.8 and 39.4 to 60.8 respectively. Based on the experimental results, a semi-empirical green bed voidage model was improved in two aspects. One is applying a one dimensional packing algorithm to get the ideal porosity of dry coarse particles utilising size distribution data rather than the simple log-normal deviation parameter. The other is to add a probability term considering the deformation of granules only happens to the adhering layer. Combined with the widely accepted population balance granulation model developed by Litster, the improved model can give more accurate predicted voidage values for modeling the sintering process and optimizing actual production from the properties of raw materials and moisture content.

Relationship Between Iron Ore Granulation Mechanisms, Granule Shapes, and Sinter Bed Permeability

Characterization of Granule Structure and Packed Bed Properties of Iron Ore Sinter Feeds That Contain Concentrate

Evaluation of Compressive Strength and Shear Strength of the Adhering Layer of Granules in Iron Ore Sintering

Optimising method for improving granulation effectiveness of iron ore sintering mixture

Taguchi Orthogonal Test On Granule Properties And Porosity Distribution In Sintering Bed Using High-Resolution X-Ray Computed Tomography

Evaluating the Permeability Properties of Green Bed in Iron Ore Sintering Using High Resolution X-ray Computed Tomography and Orthogonal Array Tests

Effect of characteristics of coarse iron ores on the granulation behaviour of concentrates in the sintering process

Influence of nature and particle size distribution on granulation of iron ore mixtures used in a sinter strand

Evaluation of Granule Structure and Strength Properties of Green Packed Beds in Iron Ore Sintering Using High-Resolution X-ray Tomography and Uniaxial Compression Testing

Experimental Study On Crushing Strength And Young'S Modulus Of Granules In Iron Ore Sintering Using Taguchi Method

Improvement in the Permeability of Sintering Beds by Drying Treatment after Granulating Sinter Raw Materials Containing Concentrates

Effect of Granule’s Moisture on Granulation Rate of Iron Ore

Influence of Binder Dosage on Granule Structure and Packed Bed Properties in Iron Ore Sintering Process

Rheological Studies on Optimizing the Sinter Mix Granulation Mechanism to Sustain Productivity

Iron Ore Sintering: Raw Materials and Granulation

Investigation on the Evolution Characteristics of Bed Porous Structure During Iron Ore Sintering

Deciphering Correlation Between Permeability and Size of Anammox Granule: “pores As Medium”

Effect of characteristics of fine iron ores on the granulation behavior of concentrate in sintering granulation process

Experimental Study on Melt and Flow Characteristics and Pore Structure of Iron Ore

Investigation on the granulation behavior of iron ore fine in a horizontal high-shear granulator

Numerical study of the dynamic behaviour of iron ore particles during wet granulation process using discrete element method