Abstract:Environmental pollution by heavy metal ions has received worldwide attention due to their long-term toxicity, non-biodegradability and accumulation in living organisms. Mesoporous calcium-silicate material (MCSM), a cost-effective sorbent synthesized from the desilication liquor of coal fly ash, has been tested its potential for the removal of Cd(II), Cr(III), Ni(II) and Pb(II) from acidic solutions. The effect of initial concentration, m/V ratios, solution pH and ionic strength on the sorption was investigated, and the performance of the material on the removal of heavy metals from simulated wastewater was evaluated. At a m/V ratio of 2g L-1, the maximum sorption capacity of MCSM for metals follows the order: Cd(II)≈Ni(II) (5.52 mmol g-1) > Cr(III) (2.88 mmol g-1) > Pb(II) (2.17 mmol g-1). However, the capacity for Cr(III) significantly decreased with comparatively higher metal concentration due to the strong hydration of Cr(III) which destroyed the crystalline phase of material. The initial concentration had a limited positive effect on the sorption, and the removal efficiency of metals only maintained at a relatively higher level with m/V ratios of up to 2 – 5g L-1. At a low m/V ratio (0.75g L-1), sorption was significantly influenced by solution pH and competition cations under strongly acidic conditions (pHinitial= 2), and the adverse effect disappeared when solution pHinitial ≥3. At an m/V ratio of 5g L-1, the removal efficiency of metals maintained in the range of 96.2 – 100.0% varied with different heavy metal ions. Considerable uptake of Zn(II), Mn(II), Fe(III) and Cu(III) by MCSM was also observed in the simulated wastewater, and the 8 metal ions (each 0.001M) were efficiently removed and the remaining metal concentration < 0.1mg L-1 (except remaining Ni(II) concentration < 1.0mg L-1) at an m/V ratio of 20g L-1. The mechanism responsible for the sorption included surface complexation, ion exchange, and probably precipitation at a high m/V ratio (20g L-1). Ion exchange with Ca(II) in MCSM occurred when m/V ratios ≥ 2g L-1(42.1 – 89.6% for m/V = 2 – 5g L-1), whereas surface complexation would probably occur when m/V ratios less than 1g L-1 due to its structural damage by extensive dissolution to form crosslinked structure which resembles vitreous silica. The results suggest that MCSM has the potential for use as an effective and low-cost sorbent for removing hazardous metal ions from wastewater. Besides, MCSM is suitable for use as a substitute of cement and disposed by inexpensive solidification/stabilization technique after being used as a sorbent. Such a process is helpful for the simultaneous realization of the reutilization of coal fly ash and the removal of toxic metals from wastewater.

Mg/Si- and Ag-Doped Carbon-Based Media Rainwater Filtration System for Multiple Pollutants Removal

Magnesium oxide loaded mesoporous silica: Synthesis, characterisation and use in removing lead and cadmium from water supplies

Porous Silicon Nanoparticles Conjugated Magnetite‐Chitosan Graphene Oxide Nanoparticles for Effective Removal of Complex Pollutants

Combined dual-size foam glass media filtration process with micro-flocculation for simultaneous removal of particulate and dissolved contaminants in urban road runoff

An Upflow-Type Filtration Device Using Expanded Polypropylene Media (EPM) to Treat First Flush of Rainwater

High efficiency filter: Cellulose-derived biochar fibril and magnesium oxide composite for boosting performance of heavy metal ions capture

Simultaneous removal of nutrients and biological pollutants via specialty absorbents in a water filtration system for watershed remediation

Application of Mesoporous Silicas for Adsorption of Organic and Inorganic Pollutants from Rainwater

Electrospun amine-functionalized silica nanoparticles - cellulose acetate nanofiber membranes for effective removal of hardness and heavy metals (As(V), Cd(II),Pb(II)) in drinking water sources

Removal of As(V) and Sb(V) in aqueous solution by Mg/Al-layered double hydroxide-incorporated polyethersulfone polymer beads (PES-LDH)

Chelant-Assisted Depollution of Metal-Contaminated Fe-Coated Sands and Subsequent Recovery of the Chemicals Using Solid-Phase Extraction Systems

Coal Fly Ash-Derived Mesoporous Calcium-Silicate Material (mcsm) for the Efficient Removal of Cd(Ii), Cr(Iii), Ni(Ii) and Pb(Ii) from Acidic Solutions

Multi-soil-layer System for Treatment of Polluted River Water Flowing into Dianchi Lake

Performance evaluation of polyethersulfone membranes modified with poly (acrylic acid‐co‐N‐vinyl pyrrolidone) grafted mesoporous carbon nitride for effective removal of cadmium(II) from wastewater

Desorption of micropollutant from spent carbon filters used for water purifier

Simultaneous Efficient Decontamination of Bacteria and Heavy Metals via Capacitive Deionization Using Polydopamine/Polyhexamethylene Guanidine Co-deposited Activated Carbon Electrodes

Study of the Factors Influencing the Adsorption of Heavy Metal Pollutants in Water by Activated Carbon Gel Particles

Amidoxime-Functionalized Macroporous Carbon Self-Refreshed Electrode Materials for Rapid and High-Capacity Removal of Heavy Metal from Water

Progress in Emerging Contaminants Removal by Adsorption/Membrane Filtration-Based Technologies: A Review

Ordered mesoporous carbons and their corresponding column for highly efficient removal of microcystin-LR

Green and cost-efficient functionalized clay adsorbent enables one-step ultraefficient removal of Pb(II) at very low and high concentrations