Abstract:We propose a natural model to probe in a controlled fashion the instability of interacting vortex rings shed from the edge of an oblate spheroid disk of major diameter c, undergoing oscillations of frequency f_{0} and amplitude A. We perform a Floquet stability analysis to determine the characteristics of the instability modes, which depend strongly on the azimuthal (integer) wave number m. We vary two key control parameters, the Keulegan-Carpenter number K_{C}=2πA/c and the Stokes number β=f_{0}c^{2}/ν, where ν is the kinematic viscosity of the fluid. We observe two distinct flow regimes. First, for sufficiently small β, and hence low frequency of oscillation corresponding to relatively weak interaction between sequentially shedding vortex rings, symmetry breaking occurs directly to a single unstable mode with m=1. Second, for sufficiently large yet fixed values of β, corresponding to a higher oscillation frequency and hence stronger ring-ring interaction, the onset of asymmetry is predicted to occur due to two branches of high m instabilities as the amplitude is increased, with m=1 structures being dominant only for sufficiently large values of K_{C}. These two branches can be distinguished by the phase properties of the vortical structures above and below the disk. The region in (K_{C},β) parameter space where these two high m instability branches arise can be described accurately in terms of naturally defined Reynolds numbers, using appropriately chosen characteristic length scales. We subsequently carry out direct numerical simulations of the fully three-dimensional flow to verify the principal characteristics of the Floquet analysis, in particular demonstrating that high wave-number symmetry-breaking generically occurs when vortex rings sequentially interact sufficiently strongly.

Simulations of the formation of an axisymmetric vortex ring

On the formation of vortex rings and pairs

Numerical simulation of the postformation evolution of a laminar vortex ring

An axisymmetric steady state vortex ring model

Modification of Flow Transition for a Vortex Ring by a Bubble Released at the Axis

Vortex ring pairs: numerical simulation and experiment

Direct numerical simulation of a laminar vortex ring

Three-dimensional numerical simulation of a vortex ring impinging on a circular cylinder

A theoretical model on vortex ring formation based on the roll-up of a vortex sheet with finite thickness

Thermal vortex ring: vortex-dynamics analysis of a high-resolution simulation

Formation of Thermal Vortex Rings

4D visualization study of a vortex ring life cycle using modal analyses

Ring Vortex Dynamics Following Jet Formation of a Bubble Expanding and Collapsing Close to a Flat Solid Boundary Visualized via Dye Advection in the Framework of OpenFOAM

Direct numerical simulation of vortex ring evolution from the laminar to the early turbulent regime

Numerical experiments on vortex ring formation

Vortex rings impinging on walls: axisymmetric and three-dimensional simulations

Evolution of an elliptic vortex ring in a viscous fluid

Simulation of vortex induced vibration of turbulent flow around a circular cylinder by plane turbulent models

Instabilities of interacting vortex rings generated by an oscillating disk.

Dynamics and Instability of A Vortex Ring Impinging on A Wall

Coherent Structures in Interacting Vortex Rings