Contribution of Road Vehicle Tyre Wear to Microplastics and Ambient Air Pollution

Barouch Giechaskiel,Theodoros Grigoratos,Marcel Mathissen,Joris Quik,Peter Tromp,Mats Gustafsson,Vicente Franco,Panagiota Dilara

DOI: https://doi.org/10.3390/su16020522

IF: 3.9

2024-01-07

Sustainability

Abstract:Tyre particles are generated by shear forces between the tread and the road or by volatilisation. Tyre abrasion (wear) contributes from one-third to half of microplastics unintentionally released into the environment. The major part ends up in the soil, a considerable amount is released into the aquatic environment, and a small percentage becomes airborne. Nevertheless, tyre abrasion contributes to 5–30% of road transport particulate matter (PM) emissions. This corresponds to approximately 5% of total ambient PM emissions. The particle mass size distribution peak at around 20 to 100 μm, with a second peak in the 2–10 μm range. A nucleation mode has been reported in some studies. The absolute abrasion levels depend on the tyre, vehicle, and road characteristics, but also on environmental conditions and driving style. Most tyre particle emission factors in the literature are based on data prior to the year 2000. We aggregated recent studies and found a mean abrasion of 110 mg/km per vehicle or 68 mg/km/t for passenger cars (based on approximately 300 measurements). Based on a limited number of studies, the PM10 emissions were 1.4–2.2 mg/km per tyre. On the other hand, the particle number emissions were in the order of 1010 #/km per tyre. The ratio of PM10 to total abrasion was found to be 2.5% on average. Finally, the ratio of PM2.5 to PM10 was calculated to be around 40%. Various mitigation measures for tyre particle pollution could be envisaged; the most direct is the limitation of the tyre abrasion rate, as proposed by the European Commission for the Euro 7 regulation. Other regulatory initiatives are also discussed.

environmental sciences,environmental studies,green & sustainable science & technology

What problem does this paper attempt to address?

The problem that this paper attempts to solve is the contribution of tire wear to micro - plastic pollution and particulate matter (PM) pollution in ambient air. Specifically, the paper focuses on the following aspects:

1. **Micro - plastics generated by tire wear**: During the use of tires, tiny plastic particles will be generated due to friction, and these particles will eventually enter the soil, water bodies and the atmosphere, becoming part of the micro - plastic pollution. The potential impact of micro - plastics on the environment and biological health is a new and emerging global threat.

2. **The impact of tire wear on air particulate matter pollution**: Tire wear not only generates micro - plastics, but also releases fine particulate matter, which will have a negative impact on air quality. In particular, particulate matter with a diameter less than 10 micrometers (PM 10) and 2.5 micrometers (PM 2.5) can be suspended in the air for a long time and pose a threat to human health.

3. **Insufficiency of existing data**: Many studies on tire - wear emissions are based on data before 2000, and these data may not accurately reflect the current situation. Therefore, the paper also attempts to provide more accurate tire - wear emission factors and particulate matter characteristics by aggregating recent research data.

4. **Regulations and mitigation measures**: The paper discusses the policy measures taken by the European Union and other international organizations to reduce tire - wear pollution, including proposing suggestions to limit the tire - wear rate and exploring other possible mitigation measures.

### Formula summary

- **Mass distribution of tire - wear particles**:
- The main peak appears between 20 and 100 micrometers.
- The second peak appears in the range of 2 to 10 micrometers.
- The nucleation mode has also been reported in some studies.

- **Tire - wear emission factors**:
- The average amount of vehicle - tire wear per kilometer is 110 mg/km.
- For passenger cars, the average amount of tire wear per kilometer is 68 mg/km.
- The PM 10 emission amount is 1.4 - 2.2 mg/km/tire.
- The particle number emission amount is approximately \(10^{10}\) particles/km/tire.

- **Proportion of particulate matter**:
- The proportion of PM 10 in the total wear amount is on average 2.5%.
- The proportion of PM 2.5 in PM 10 is approximately 40%.

Through these studies and data analyses, the paper aims to provide a scientific basis for policy - makers and researchers to better understand and address the environmental pollution problems caused by tire wear.