Abstract:International emission tests (EPA, SFTP, MVEG-B, J-10.15, etc.) are carried out with vehicles running on the rolls dynamometer. Results, in terms of total emissions, are influenced by vehicles parameters such as mass, gear ratios, front surface, drag coefficient, etc. It would be useful, in the automobiles design phase, to have information about the impact of these parameters on total emissions. The obvious solution would be to build up a complete vehicle model to simulate performance and emission levels. Engine pollutants production modeling is the weak point, since it is difficult to obtain reliable results. Anyway it is possible to avoid pollutants production simulation, testing the actual engine under the same operating condition it would face inside the car’s hood. This paper describes a methodology whose aim is to test the engine on a standard test bench, simulating on-board operating conditions. An equivalence condition has to be satisfied in order to guarantee the methodology effectiveness: engine speed and Manifold Absolute Pressure (MAP) must always match for the two types of test performed on the same driving cycle. Engine speed and torque can be controlled through the bench actuators, their values depending on the simulated vehicle motion: once the car dynamics are simulated by means of a model, engine speed and torque corresponding to the given driving cycle can in fact be evaluated. The model is solved in real time, its output being the brake load torque value satisfying the equivalence condition. The brake controller, used as a slave, regulates the engine operating conditions consequently. The global model incorporates tires, aerodynamic forces, clutch, gearbox and driveline behaviors simulation: its response has been first validated comparing its outputs with data measured on board, and then it has been used to control an eddy current brake, for vehicle test simulation on the test bench. Two different control philosophies can be used: either a human driver or an automatic controller can ride the simulated car. The influence of vehicle parameters and gearshift mode on fuel consumption and pollutant emissions can be investigated.

Analysis of the Euro 7 on-board emissions monitoring concept with real-driving data

Application of automotive safety design methodologies to the development of Euro 7 emission control systems including on board monitoring.

Study on CO2 Emission Assessment of Heavy-Duty and Ultra-Heavy-Duty Vehicles Using Machine Learning

Regulatory Insights for On-Board Monitoring of Vehicular NOx Emission Compliance

Euro 6 Unregulated Pollutant Characterization and Statistical Analysis of After-Treatment Device and Driving-Condition Impact on Recent Passenger-Car Emissions

Towards Simpler Approaches for Assessing Fuel Efficiency and CO2 Emissions of Vehicle Engines in Real Traffic Conditions Using On-Board Diagnostic Data

Estimation of Pollutant Emissions in Real Driving Conditions Based on Data from OBD and Machine Learning

An innovative virtual sensing system for the vehicle-centric evaluation of emissions in the sustainable mobility transition

Analysis of exhaust emission processes during the Real Driving Emissions test

On-board monitoring (OBM) for heavy-duty vehicle emissions in China: Regulations, early-stage evaluation and policy recommendations

NOx, NH3, N2O and PN real driving emissions from a Euro VI heavy-duty vehicle. Impact of regulatory on-road test conditions on emissions

On-Board Sensor-Based NO x Emissions from Heavy-Duty Diesel Vehicles

Novel approach for connecting real driving emissions to the European vehicle laboratorial certification test procedure

Monitoring Euro 6 diesel passenger cars NOx emissions for one year in various ambient conditions with PEMS and NOx sensors

Euro 7 proposal assessment of a Euro VI parallel hybrid electric bus

Experimental Assessment of NOx Emissions from 73 Euro 6 Diesel Passenger Cars

Real-world gaseous and particulate emissions from Euro IV to VI medium duty diesel trucks

Real-Time Emission Prediction with Detailed Chemistry under Transient Conditions for Hardware-in-the-Loop Simulations

Vehicle Simulation on the Test Bench

Using Multi-Source Data to Identify High-Emitting Heavy-Duty Diesel Vehicles

A TinyML Soft-Sensor Approach for Low-Cost Detection and Monitoring of Vehicular Emissions