Abstract:Photocatalytic hydrogen generation by solar energy is a promising approach to clean energy resource and has attracted great attention over the past decades. [1] Perovskites ABO3 structures provide the basic stable framework to both crystal and electronic structures modification, which have found extensive applications in photocatalysis, solar cells and photoelectrochemical (PEC) water splitting. [2] LaFeO3 has a suitable band gap of 2.07eV [3, 4] and exhibits excellent visible light photocatalytic performance. However, the poor charge transport and slow reaction kinetics at the surface [3, 4] are the main factors limiting its further improvement on photocatalytic application. To overcome these obstacles, transition metals (Mn, Co, Cu) are introduced into LaFeO3 and the photocurrent of 10% Cu doped sample is improved by three times than that of LaFeO3. The reduced charge transport resistance owing to the Fe3+ discharge is identified to benefit the PEC performance improvement after TM doping. On the other hand, the surface state of LaFeO3 is modified by electrodepositing of amorphous cobalt-phosphate (Co-Pi). It shows that the presence of Co-Pi down-shifts the onset potential by ~ 560 mV for anodic photocurrent and the improvement can be attributed to the enhanced water oxidation due to the CoII/CoIII-OH discharge on Co-Pi decorated layers. The transition anodic photocurrent is improved by about six times after Co-Pi coating under visible light at 0.50 V vs. Ag/AgCl and the electrochemical impedance spectroscopy certifies the enhanced charge transfer, which contributes to the meliorative anodic photocurrent. The incident photon-to-current conversion efficiencies of LaFeO3 can be promoted from 1.37% to 2.14% at 400 nm after Co-Pi coating. Our results demonstrate that modification of the electronic structure (TM doping) and surface state (Co-Pi coating) are the promising way to promote the photoconversion efficiency of LaFeO3-based PEC cells under visible light. References: X. Lu, S. Xie, H. Yang, Y. Tong, H. Ji, Chem. Soc. Rev., 43, 7581 (2014). Z. G. Yi and J. Ye, Appl. Phys. Lett., 91, 254108 (2007). K. M. Parida, K. H. Reddy, S. Martha, D. P. Das and N. Biswal, Int. J. Hydrogen Energy, 35, 12161 (2010). Q. Peng, B. Shan, Y. Wen and R. Chen, Int. J. Hydrogen Energy, 40, 15423 (2015).

Cation-deficiency induced spin regulation enhancement photo-assisted electrocatalytic wastewater splitting

Cation defect engineering in LaCoO 3 perovskite as the "Two birds one stone" strategy to enhanced Fenton-like reaction: Regulating Co spin state and optimizing electron transfer ability

Modification of the Electronic Structure and Surface State of LaFeO3 for Improved Visible Light Photoelectrochemical Water Oxidation

Engineering Phosphorus-Doped LaFeO3-δ Perovskite Oxide As Robust Bifunctional Oxygen Electrocatalysts in Alkaline Solutions

The roles of oxygen vacancies in LaFeO 3 photocathodes in photoelectrochemical water splitting

Cobalt-doped LaFeO3 for photo-Fenton degradation of organic pollutants and visible-light-assisted water splitting

Low‐Spin Fe3+ Evoked by Multiple Defects with Optimal Intermediate Adsorption Attaining Unparalleled Performance in Water Oxidation

Enhanced Charge Transport of LaFeO3 Via Transition Metal (mn, Co, Cu) Doping for Visible Light Photoelectrochemical Water Oxidation

Enhancing Electrocatalytic Activity of Perovskite Oxides by Tuning Cation Deficiency for Oxygen Reduction and Evolution Reactions

Enhanced Photoelectrochemical Water Oxidation by Fabrication of p-LaFeO3/n-Fe2O3 Heterojunction on Hematite Nanorods

Coupling ferromagnetic ordering electron transfer channels and surface reconstructed active species for spintronic electrocatalysis of water oxidation

Tailoring the cationic and anionic sites of LaFeO 3 -based perovskite generates multiple vacancies for efficient water oxidation

Optimizing Water Oxidation Kinetics by Modulating Spin Alignment Through Non-metal Vacancy Engineering

Engineering Charge Redistribution Within Perovskite Oxides for Synergistically Enhanced Overall Water Splitting

Regulating the Spin State of Fe III Enhances the Magnetic Effect of the Molecular Catalysis Mechanism

Electrolyte Modification Method Induced Atomic Arrangement in FeOx/NF Nanosheets for Efficient Overall Water Splitting

Electrochemical Synthesis of Cation Vacancy-Enriched Ultrathin Bimetallic Oxyhydroxide Nanoplatelets for Enhanced Water Oxidation

Modulating Photoelectrochemical Water-Splitting Activity by Charge Storage Capacity of Electrocatalysts

Ultrahigh Efficient Water Oxidation under Visible Light: Using Fe Dopants to Integrate Nanostructure and Cocatalyst in LaTiO2N System

Valence Engineering Via Selective Atomic Substitution on Tetrahedral Sites in Spinel Oxide for Highly Enhanced Oxygen Evolution Catalysis

Controllable La Deficiency Engineering within Perovskite Oxides for Enhanced Overall Water Splitting