Abstract:This study establishes detailed neural network modeling procedures for the combustion optimization of a power generation unit, equipped with a Selective Catalytic Reduction (SCR) system. In particular, artificial intelligence neural networks were applied due to its capability in treating large pools of data of great nonlinearity. The objective of this study was to reduce nitrogen oxide (NOx) emissions in the stack gas, lower the cost of emissions compliance and minimize the net unit heat rate at this power generation unit at full-load conditions. These procedures include building a database with real coal power plant operating data, modeling the database and using the genetic algorithm to optimize the operating conditions. The operation is optimized with respect to the steam temperature, selective catalyst reactor, and separated over-fire air conditions. Verifications of the results demonstrated that by carrying out the reported study, the pollutant concentrations of the boiler are significantly decreased and the catalyst layer is effectively preserved, while the operation can be maintained stable near the full-load condition. It was found that the average ammonia (NH3) flow to the SCR under optimized conditions was 229 kg/h, while the average NH3 flow under non-optimal operational conditions was 260 kg/h, resulting in a reduction in NH3 consumption of approximately 12 % from the non-optimized operational condition. In the meantime, the SCR inlet (boiler exit) NOx was reduced from 523 mg/Nm3 (non-optimized operational condition) to 444 mg/Nm3 (optimized operational condition), which represent about 15 % reduction. Based on the experience with SCR from manufactures and operators, the SCR catalyst life expectancy has a direct relationship with the SCR inlet NOx concentration and NH3 injection rate. The lower the NOx concentration at the SCR inlet and the less the NH3 injection rate, the longer of the SCR catalyst life will be. Thus, it is expected that the SCR catalyst layer replacement frequency could be reduced by 10 to 20 % over the normal catalyst replacement cycle, while meeting the same environmental NOx emissions limit. Additionally, a Delta Heat Rate was also calculated using best available data from the optimized operational conditions, including boiler load, boiler excess oxygen (O2), fly ash unburned carbon and attemperation flow. Results were compared with the average Delta Heat Rate calculated from baseline tests. It was found that the average Delta Heat Rate from baseline tests are −60 kJ/kWh, while the delta heat rate from the optimized operation condition hours is −118 kJ/kWh. This represents about 0.57 % improvement on unit heat rate from the baseline average.

Strategic-level performance enhancement of a 660 MWe supercritical power plant and emissions reduction by AI approach

Optimization of a 660 MWe Supercritical Power Plant Performance—A Case of Industry 4.0 in the Data-Driven Operational Management Part 1. Thermal Efficiency

Artificial intelligence driven smart operation of large industrial complexes supporting the net-zero goal: Coal power plants

Advanced Exergoenvironmental Evaluation for a Coal-Fired Power Plant of Near-Zero Air Pollutant Emission

Artificial intelligence enabled efficient power generation and emissions reduction underpinning net-zero goal from the coal-based power plants

Combustion optimization of ultra supercritical boiler based on artificial intelligence

Combustion optimization of a coal-fired power plant boiler using artificial intelligence neural networks

Reduction of emissions and improvement of dynamic responses of a supercritical clean coal generation unit via neural network inverse control strategy

Performance prediction of a clean coal power plant via machine learning and deep learning techniques

ANN-GA based optimization of a high ash coal-fired supercritical power plant

Optimization of a 660 MWe Supercritical Power Plant Performance—A Case of Industry 4.0 in the Data-Driven Operational Management. Part 2. Power Generation

Operation Data Analysis and Performance Optimization of the Air-Cooled System in a Coal-Fired Power Plant Based on Machine Learning Algorithms

Comparative analysis and prediction study for effluent gas emissions in a coal-fired thermal power plant using artificial intelligence and statistical tools

Development of novel dynamic machine learning-based optimization of a coal-fired power plant

Performance analysis of an efficient waste heat utilization system in an ultra-supercritical coal-fired power plant

Parametric optimization of supercritical power plants using gradient methods

Investigation of Supercritical Power Plant Boiler Combustion Process Optimization through CFD and Genetic Algorithm Methods

A case study of digital-twin-modelling analysis on power-plant-performance optimizations

Dynamic Comprehensive Evaluation of a 660 MW Ultra-Supercritical Coal-Fired Unit Based on Improved Criteria Importance through Inter-Criteria Correlation and Entropy Weight Method

Modeling and Reduction of NOX Emissions for a 700 MW Coal-Fired Boiler with the Advanced Machine Learning Method