Abstract:This paper reports a new stick-slip piezoelectric linear actuator with large load density, compact size, and high resolution. It is devised using a dual-arch bridge-type driving mechanism (DBDM) and an integrated elliptical preload mechanism(IEPM). The DBDM can generate a coupling motion on the driving point, which provides clamping and releasing actions during stick-slip motion. Also, the DBDM can magnify the clamping force with large amplification ratios, thus improving driving force and load-carrying capacity. The IEPM uses compact flexure hinges to adjust preload force, reducing structural dimension. Then, theoretical analysis and simulations are conducted, and a prototype is fabricated. A modified driving voltage with smooth turning points is designed to improve motion properties further. Experiments show that load density is 0.037 g/mm $^{\mathbf{3}}$ under the driving voltage of 100 V. The actuator has an overall size of 33.6 mm $\times$ 20 mm $\times$ 8 mm and a displacement resolution of 22 nm. Note to Practitioners —Most research on linear actuators focused on motion displacement improvement, and more research needs to be done on improving load-carrying capacity. Therefore, this paper designs a force amplification linear actuator with a compact structure using the DBDM. In the experimental stage, the sudden change of the driving signal affects the output performance, and a modified sawtooth voltage is used to improve the output speed and load-carrying capacity. The experimental results show that under the modified sawtooth wave voltage, the maximum speed of the slider is 1.4 mm/s, and the speed is increased by 17% compared with the traditional wave. When a 200 g load is applied to the slider, the linear actuator operates at a stable speed of 1.2 $\mu $ m/s, 33% faster than conventional sawtooth waves. As a result, the designed actuator has superior performance at higher loads.

A stick-slip piezoelectric actuator with suppressed backward motion achieved using an active locking mechanism (ALM)

Research on rotational rollback suppression of diamond-shaped active locking flexure mechanism (ALFM) driven by piezoelectric wafers

A dual-mode stick-slip piezoelectric actuator imitating mantis forefoot

Design and performance evaluation of a stick-slip actuator with Z-shaped beam and two-stage amplification system

Achieving smooth motion in displacement amplification piezoelectric stick-slip actuator

Design and Analysis of a Stepping Piezoelectric Actuator Free of Backward Motion

Compact stick–slip piezoelectric rotary motor with reduced undesired backward motion

A New Stick-Slip Piezoelectric Actuator Using Dual-Arch Bridge-Type Compliant Mechanisms

Achieving Smooth Motion for Piezoelectric Stick–Slip Actuator With the Inertial Block Structure

Experiments and Study of a Low-Frequency, High-Speed Bi-Directional Piezoelectric Stick-Slip Actuator

Achieving smooth motion of stick–slip piezoelectric actuator by means of alternate stepping

Improving Load Capacity of Stick-Slip Actuators in Both Driving Directions Via a Shared Driving Foot

Design and Experiment of a Clamping-Drive Alternating Operation Piezoelectric Actuator

A Gravity-Assisted Piezoelectric Inertial Actuator for Bidirectional Smooth Drives by Single Excitation Source

A piezoelectric inertial actuator operating with elliptical drive and stick-slip drive modes

Achieving Stable and Effective Stick-Slip Motions of Piezoelectric Actuators With a Small Mass Rotor by Means of the Auxiliary Friction

A flexure hinged piezoelectric stick–slip actuator with high velocity and linearity for long-stroke nano-positioning

A new stick-slip type piezoelectric actuator based on asymmetric diamond-shaped flexure hinge structure

An Anisotropic Biomimetic Lemongrass Flexible Piezoelectric Actuator - Inhibitory Regression

Modeling and experimental evaluation of the stepping characteristic on a walking-type piezoelectric actuator

A Novel 2-DOF Piezoelectric Stick-Slip Actuator With Parallel Guiding Decoupling